From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from m2.goneo.de ([82.100.220.83]:58327 "EHLO m2.goneo.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1755834AbZIUNzI convert rfc822-to-8bit (ORCPT ); Mon, 21 Sep 2009 09:55:08 -0400 From: Roman To: Antti Palosaari Subject: Re: MSI Digivox mini III Remote Control Date: Mon, 21 Sep 2009 15:55:11 +0200 Cc: "Aleksandr V. Piskunov" , "linux-media@vger.kernel.org" References: <200909202026.27086.lists@hasnoname.de> <20090921115122.GA2269@moon> <4AB77329.5000405@iki.fi> In-Reply-To: <4AB77329.5000405@iki.fi> MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 8BIT Content-Disposition: inline Message-Id: <200909211555.11747.lists@hasnoname.de> Sender: linux-media-owner@vger.kernel.org List-ID: Am Monday 21 September 2009 14:35:53 schrieb Antti Palosaari: > On 09/21/2009 02:51 PM, Aleksandr V. Piskunov wrote: > > Just grab that patch and apply it to the current vl4-dvb, no need to mess > > with old repository. > > http://linuxtv.org/hg/~anttip/af9015-digivox3_remote/raw-rev/914ded6d921d > > With this patch remote will not work most likely. But after adding that > patch you should see remote events dumped to the /var/log/messages when > key is pressed. I need to know which key gives which code. After that I > can add correct key mappings to the driver. > > Antti I don't get anything else in the logs than this, even with the patch applied: #--- Sep 21 15:43:04 Seth usbcore: registered new interface driver dvb_usb_af9015 Sep 21 15:43:07 Seth usb 1-5: new high speed USB device using ehci_hcd and address 4 Sep 21 15:43:08 Seth usb 1-5: configuration #1 chosen from 1 choice Sep 21 15:43:08 Seth dvb-usb: found a 'MSI Digi VOX mini III' in cold state, will try to load a firmware Sep 21 15:43:08 Seth usb 1-5: firmware: requesting dvb-usb-af9015.fw Sep 21 15:43:08 Seth dvb-usb: downloading firmware from file 'dvb-usb-af9015.fw' Sep 21 15:43:08 Seth dvb-usb: found a 'MSI Digi VOX mini III' in warm state. Sep 21 15:43:08 Seth dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. Sep 21 15:43:08 Seth DVB: registering new adapter (MSI Digi VOX mini III) Sep 21 15:43:08 Seth af9013: firmware version:4.95.0 Sep 21 15:43:08 Seth DVB: registering adapter 0 frontend 0 (Afatech AF9013 DVB-T)... Sep 21 15:43:08 Seth tda18271 3-00c0: creating new instance Sep 21 15:43:08 Seth TDA18271HD/C1 detected @ 3-00c0 Sep 21 15:43:08 Seth dvb-usb: MSI Digi VOX mini III successfully initialized and connected. Sep 21 15:43:51 Seth [drm] LVDS-8: set mode 1024x768 10 #--- Gruß, Roman -- When I was in school, I cheated on my metaphysics exam: I looked into the soul of the boy sitting next to me. -- Woody Allen