[PATCH v2 02/12] [media] dvb-frontends/stv0367: print CPAMP status only if stv_debug is enabled

[Daniel Scheller <d.scheller.oss@gmail.com>]

From: Daniel Scheller <d.scheller@gmx.net>

The CPAMP log lines generated in stv0367_ter_check_cpamp() are printed
everytime tuning succeeds or fails, quite cluttering the normal kernel log.
Use dprintk() instead of printk(KERN_ERR...) so that if the information is
needed, it'll be printed when the stv_debug modparam is enabled.

Signed-off-by: Daniel Scheller <d.scheller@gmx.net>
---
 drivers/media/dvb-frontends/stv0367.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/media/dvb-frontends/stv0367.c b/drivers/media/dvb-frontends/stv0367.c
index fc80934..0064d9d 100644
--- a/drivers/media/dvb-frontends/stv0367.c
+++ b/drivers/media/dvb-frontends/stv0367.c
@@ -1262,9 +1262,9 @@ stv0367_ter_signal_type stv0367ter_check_cpamp(struct stv0367_state *state,
 	dprintk("******last CPAMPvalue= %d at wd=%d\n", CPAMPvalue, wd);
 	if (CPAMPvalue < CPAMPMin) {
 		CPAMPStatus = FE_TER_NOCPAMP;
-		printk(KERN_ERR "CPAMP failed\n");
+		dprintk("%s: CPAMP failed\n", __func__);
 	} else {
-		printk(KERN_ERR "CPAMP OK !\n");
+		dprintk("%s: CPAMP OK !\n", __func__);
 		CPAMPStatus = FE_TER_CPAMPOK;
 	}
 
-- 
2.10.2