[PATCH] media: dt-bindings: rcar_vin: Document RZ/G1 per-board settings

Geert Uytterhoeven
2019-10-24T13:14:38Z

The R-Car Gen2 per-board settings apply to RZ/G1, too.

Fixes: 1d14a5eaa156b0b3 ("media: dt-bindings: media: rcar_vin: add device tree support for r8a774[35]")
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
---
Documentation/devicetree/bindings/media/renesas,vin.txt | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/media/renesas,vin.txt b/Documentation/devicetree/bindings/media/renesas,vin.txt
index aa217b0962797712..221fcc416d1ac598 100644
--- a/Documentation/devicetree/bindings/media/renesas,vin.txt
+++ b/Documentation/devicetree/bindings/media/renesas,vin.txt
@@ -43,7 +43,7 @@ on Gen3 and RZ/G2 platforms to a CSI-2 receiver.
Additionally, an alias named vinX will need to be created to specify
which video input device this is.

-The per-board settings Gen2 platforms:
+The per-board settings for Gen2 and RZ/G1 platforms:

- port - sub-node describing a single endpoint connected to the VIN
from external SoC pins as described in video-interfaces.txt[1].
@@ -63,7 +63,7 @@ The per-board settings Gen2 platforms:
- data-enable-active: polarity of CLKENB signal, see [1] for
description. Default is active high.

-The per-board settings Gen3 and RZ/G2 platforms:
+The per-board settings for Gen3 and RZ/G2 platforms:

Gen3 and RZ/G2 platforms can support both a single connected parallel input
source from external SoC pins (port@0) and/or multiple parallel input sources
--
2.17.1