Re: [PATCH v3 4/9] media: dt-bindings: cadence-csi2rx: Add resets property

[Laurent Pinchart <laurent.pinchart@ideasonboard.com>]

Hi Jack,

Thank you for the patch.

On Fri, Mar 31, 2023 at 08:18:21PM +0800, Jack Zhu wrote:
> Add resets property for Cadence MIPI-CSI2 RX controller
> 
> Signed-off-by: Jack Zhu <jack.zhu@starfivetech.com>

Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>

> ---
>  .../bindings/media/cdns,csi2rx.yaml           | 24 +++++++++++++++++++
>  1 file changed, 24 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/media/cdns,csi2rx.yaml b/Documentation/devicetree/bindings/media/cdns,csi2rx.yaml
> index 89f414eeef47..f8da4a35e98e 100644
> --- a/Documentation/devicetree/bindings/media/cdns,csi2rx.yaml
> +++ b/Documentation/devicetree/bindings/media/cdns,csi2rx.yaml
> @@ -38,6 +38,24 @@ properties:
>        - const: pixel_if2_clk
>        - const: pixel_if3_clk
>  
> +  resets:
> +    items:
> +      - description: CSI2Rx system reset
> +      - description: Gated Register bank reset for APB interface
> +      - description: pixel reset for Stream interface 0
> +      - description: pixel reset for Stream interface 1
> +      - description: pixel reset for Stream interface 2
> +      - description: pixel reset for Stream interface 3
> +
> +  reset-names:
> +    items:
> +      - const: sys
> +      - const: reg_bank
> +      - const: pixel_if0
> +      - const: pixel_if1
> +      - const: pixel_if2
> +      - const: pixel_if3
> +
>    phys:
>      maxItems: 1
>      description: MIPI D-PHY
> @@ -120,6 +138,12 @@ examples:
>          clock-names = "sys_clk", "p_clk",
>                        "pixel_if0_clk", "pixel_if1_clk",
>                        "pixel_if2_clk", "pixel_if3_clk";
> +        resets = <&bytereset 9>, <&bytereset 4>,
> +                 <&corereset 5>, <&corereset 6>,
> +                 <&corereset 7>, <&corereset 8>;
> +        reset-names = "sys", "reg_bank",
> +                      "pixel_if0", "pixel_if1",
> +                      "pixel_if2", "pixel_if3";
>          phys = <&csi_phy>;
>          phy-names = "dphy";
>  

-- 
Regards,

Laurent Pinchart