[PATCH 5/7] media: ov2740: Enable runtime PM before registering the async subdev

[Sakari Ailus <sakari.ailus@linux.intel.com>]

Enable runtime PM before registering the async sub-device as the ipu
bridge may try to resume the device immediately after the async sub-device
has been registered. If runtime PM is still disabled, this will fail.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
---
 drivers/media/i2c/ov2740.c | 14 ++++++++------
 1 file changed, 8 insertions(+), 6 deletions(-)

diff --git a/drivers/media/i2c/ov2740.c b/drivers/media/i2c/ov2740.c
index 41d4f85470fd..319dc00e47b4 100644
--- a/drivers/media/i2c/ov2740.c
+++ b/drivers/media/i2c/ov2740.c
@@ -1172,6 +1172,12 @@ static int ov2740_probe(struct i2c_client *client)
 		goto probe_error_v4l2_ctrl_handler_free;
 	}
 
+	/* Set the device's state to active if it's in D0 state. */
+	if (full_power)
+		pm_runtime_set_active(&client->dev);
+	pm_runtime_enable(&client->dev);
+	pm_runtime_idle(&client->dev);
+
 	ret = v4l2_async_register_subdev_sensor(&ov2740->sd);
 	if (ret < 0) {
 		dev_err_probe(dev, ret, "failed to register V4L2 subdev\n");
@@ -1182,16 +1188,12 @@ static int ov2740_probe(struct i2c_client *client)
 	if (ret)
 		dev_warn(&client->dev, "register nvmem failed, ret %d\n", ret);
 
-	/* Set the device's state to active if it's in D0 state. */
-	if (full_power)
-		pm_runtime_set_active(&client->dev);
-	pm_runtime_enable(&client->dev);
-	pm_runtime_idle(&client->dev);
-
 	return 0;
 
 probe_error_media_entity_cleanup:
 	media_entity_cleanup(&ov2740->sd.entity);
+	pm_runtime_disable(&client->dev);
+	pm_runtime_set_suspended(&client->dev);
 
 probe_error_v4l2_ctrl_handler_free:
 	v4l2_ctrl_handler_free(ov2740->sd.ctrl_handler);
-- 
2.39.2