[RFC v5 01/15] media: Documentation: Rework embedded data documentation

[Sakari Ailus <sakari.ailus@linux.intel.com>]

Rework embedded data documentation by removing the reference to the pixel
data stream. The specific documentation of the embedded data interface
will be elsewhere, in the near future either CCS or common raw camera
sensor model documentation.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Reviewed-by: Jacopo Mondi <jacopo.mondi@ideasonboard.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Reviewed-by: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>
---
 .../userspace-api/media/drivers/camera-sensor.rst   | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)

diff --git a/Documentation/userspace-api/media/drivers/camera-sensor.rst b/Documentation/userspace-api/media/drivers/camera-sensor.rst
index dc415b8f6c8e..8e1083417ae1 100644
--- a/Documentation/userspace-api/media/drivers/camera-sensor.rst
+++ b/Documentation/userspace-api/media/drivers/camera-sensor.rst
@@ -111,13 +111,12 @@ the sensor configuration for the captured frame back to the host. While CSI-2 is
 the most common data interface used by such sensors, embedded data can be
 available on other interfaces as well.
 
-Such sensors expose two internal sink pads (pads that have both the
-``MEDIA_PAD_FL_SINK <MEDIA-PAD-FL-SINK>`` and ``MEDIA_PAD_FL_INTERNAL
-<MEDIA-PAD-FL-INTERNAL>`` flags set) to model the source of the image and
-embedded data streams. Both of these pads produces a single stream, and the
-sub-device routes those streams to the external (source) pad. If the sub-device
-driver supports disabling embedded data, this can be done by disabling the
-embedded data route via the ``VIDIOC_SUBDEV_S_ROUTING`` IOCTL.
+Embedded data support is indicated by the precence of an internal sink pad (pad
+that has both the ``MEDIA_PAD_FL_SINK <MEDIA-PAD-FL-SINK>`` and
+``MEDIA_PAD_FL_INTERNAL <MEDIA-PAD-FL-INTERNAL>`` flags set) with a metadata
+format to model the embedded data stream. If the sub-device driver supports
+disabling embedded data, this can be done by disabling the embedded data route
+via the ``VIDIOC_SUBDEV_S_ROUTING`` IOCTL.
 
 In general, changing the embedded data format from the driver-configured values
 is not supported. The height of the metadata is device-specific and the width
-- 
2.39.5