[PATCH] media: ccs-pll: Fix pre-PLL divider calculation for EXT_IP_PLL_DIVIDER flag

[PATCH] media: ccs-pll: Fix pre-PLL divider calculation for EXT_IP_PLL_DIVIDER flag

[Alexander Shiyan]

When the CCS_PLL_FLAG_EXT_IP_PLL_DIVIDER flag is set, odd pre-PLL divider
values are allowed. However, in the operational timing branch the
calculation of the minimum pre-PLL divider incorrectly uses clk_div_even_up,
forcing the minimum value to be even, even if the flag is set. This prevents
selecting a valid odd divider like 3, which may be required for certain
sensor configurations.

Fix this by removing the forced even rounding from the minimum pre-PLL
divider calculation. The loop later uses the flag to determine the step,
so odd values will be considered when the flag is set.

Signed-off-by: Alexander Shiyan <eagle.alexander923@gmail.com>
---
 drivers/media/i2c/ccs-pll.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/media/i2c/ccs-pll.c b/drivers/media/i2c/ccs-pll.c
index 4eb83636e102..1605cfa5db19 100644
--- a/drivers/media/i2c/ccs-pll.c
+++ b/drivers/media/i2c/ccs-pll.c
@@ -824,9 +824,8 @@ int ccs_pll_calculate(struct device *dev, const struct ccs_pll_limits *lim,
 				   op_lim_fr->min_pll_ip_clk_freq_hz));
 	min_op_pre_pll_clk_div =
 		max_t(u16, op_lim_fr->min_pre_pll_clk_div,
-		      clk_div_even_up(
-			      DIV_ROUND_UP(pll->ext_clk_freq_hz,
-					   op_lim_fr->max_pll_ip_clk_freq_hz)));
+		      DIV_ROUND_UP(pll->ext_clk_freq_hz,
+				   op_lim_fr->max_pll_ip_clk_freq_hz));
 	dev_dbg(dev, "pre-pll check: min / max op_pre_pll_clk_div: %u / %u\n",
 		min_op_pre_pll_clk_div, max_op_pre_pll_clk_div);
 
-- 
2.52.0