[linux-dvb] Hauppauge HVR-1700 Support

[Torben Viets <viets@web.de>]

Hello,

I have a Hauppauge HVR-1700 PCI Express, I have read all posts about
this card here, but I didn't get it working, how does it work?

Kernel: linux-2.6.25-git10

Firmware-Files:
ls -al /lib/firmware/2.6.25-git10/
total 416
drwxr-xr-x 2 root root     91 Apr 27 16:27 .
drwxr-xr-x 3 root root     25 Apr 27 16:26 ..
-rw-r--r-- 1 root root  24878 Apr 27 16:27 dvb-fe-tda10048-1.0.fw
-r--r--r-- 1 root root  16382 Apr 27 16:27 v4l-cx23885-avcore-01.fw
-r--r--r-- 1 root root 376836 Apr 27 16:26 v4l-cx23885-enc.fw

The modules I use are from the actual v4l-dvb hg, if I type make load,
the only thing I get is a /dev/video0, but I have no picture with xawtv...

The DVB doesn't work at all, I have no /dev/dvb*, here is my dmesg:

cx23885 driver version 0.0.1 loaded
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 24 (level, low) -> IRQ 24
CORE cx23885[0]: subsystem: 0070:8101, board: Hauppauge WinTV-HVR1700
[card=8,autodetected]
cx23885[0]: i2c bus 0 registered
cx23885[0]: i2c bus 1 registered
cx23885[0]: i2c bus 2 registered
tveeprom 0-0050: Huh, no eeprom present (err=-5)?
tveeprom 0-0050: Encountered bad packet header [00].
Corrupt or not a Hauppauge
eeprom.
cx23885[0]: warning: unknown hauppauge model #0
cx23885[0]: hauppauge eeprom: model=0
cx23885[0]: cx23885 based dvb card
tda10048_readreg: readreg error (ret == -5)
cx23885[0]: frontend initialization failed
cx23885_dvb_register() dvb_register failed err = -1
cx23885_dev_setup() Failed to register dvb on VID_C
cx23885_dev_checkrevision() New hardware revision found 0x0
cx23885_dev_checkrevision() Hardware revision unknown 0x0
cx23885[0]/0: found at 0000:02:00.0, rev: 2, irq: 24, latency: 0, mmio:
0xfe800000

Thank you and greetings
Torben Viets



_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb