From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from smtp126.rog.mail.re2.yahoo.com ([206.190.53.31]) by www.linuxtv.org with smtp (Exim 4.63) (envelope-from ) id 1KhPqT-0004xw-Iu for linux-dvb@linuxtv.org; Sun, 21 Sep 2008 16:23:30 +0200 Message-ID: <48D658BF.7040807@rogers.com> Date: Sun, 21 Sep 2008 10:22:55 -0400 From: Jonathan Coles MIME-Version: 1.0 To: linux-dvb@linuxtv.org Subject: [linux-dvb] Still unclear how to use Hauppage HVR-950 and v4l-dvb List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: linux-dvb-bounces@linuxtv.org Errors-To: linux-dvb-bounces+mchehab=infradead.org@linuxtv.org List-ID: It would really help if there was a single set of instructions specific to the HVR-950 with tests at each stage. I'm really confused as to the status of my installation. I compiled the firmware according to the instructions on http://linuxtv.org/repo/. The result: $ lsusb Bus 005 Device 002: ID 2040:7200 Hauppauge On the other hand, dmesg reports: [ 17.247610] usb 5-2: new high speed USB device using ehci_hcd and address 2 [ 17.380387] usb 5-2: unable to read config index 0 descriptor/all [ 17.380434] usb 5-2: can't read configurations, error -71 Is my firmware is properly installed or not? I'm trying to follow the instructions on your *How_to_install_DVB_device_drivers* wiki, but some vital details are missing. Which modules do I look for in lsmod? The Hauppauge_Computer_Works Wiki doesn't provide this information for the HVR-950. The instructions at http://u32.net/MythTV/WinTV-HVR-950/index.html indicate that the required modules are either em28xx or au0828 and au8522. I have modprobe'd these, but still have nothing in /dev/dvb. Any ideas as to what I am missing or how I can troubleshoot this? _______________________________________________ linux-dvb mailing list linux-dvb@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb