Re: [linux-dvb] KWorld PlusTV Dual DVB-T Stick (DVB-T 399U) / Afatech af9015 missing adapter1

From: Antti Palosaari <crope@iki.fi>
To: Andrew Williams <andrew.williams@joratech.com>,
	Jose Alberto Reguero <jareguero@telefonica.net>
Cc: linux-dvb@linuxtv.org
Subject: Re: [linux-dvb] KWorld PlusTV Dual DVB-T Stick (DVB-T 399U) / Afatech af9015 missing adapter1
Date: Mon, 22 Sep 2008 20:11:52 +0300	[thread overview]
Message-ID: <48D7D1D8.4090305@iki.fi> (raw)
In-Reply-To: <546B4176F0487A4CBA62FC16EFC1D9D603D4B9@EXCHANGE.joratech.com>

Andrew Williams wrote:
> Good day everybody,
> Apologies if this is in HTML, sending from Outlook Web Access at the moment.
> 
> I am having a problem with the KWorld PlusTV Dual DVB-T Stick (DVB-T 
> 399U) / Afatech af9015 USB stick.
> 
> Firstly, thank you very much for the effort that everybody is putting 
> into this. Much appreciated.
> 
> Back to my problem:
> 
> The above tuner only registers one adapter in /dev/dvb with the latest
> build from http://linuxtv.org/hg/~anttip/af9015/
> 
> It does that under warmboot (firmware loaded) and coldboot conditions.
> 
> I have an older driver from http://linuxtv.org/hg/~anttip/af9015/ dated 
> the 13/09/2008
> which works perfectly under coldboot conditions in that it registers 
> adapter0 and adapter1 with frontend0 under each adapter.
> Unfortunately it does not work that well under warmboot conditions as it
> registers adapter0 and adapter1 but only registers a frontend0 under 
> adapter0.
> It fails to registers frontend0 under adapter1.
> 
> Thus the reason for me to try and upgrade to a later/more current driver.
> 
> I am trying to provide as much info as possible, so my apologies if 
> there is too much text attached.
> 
> Greatly appreciate if anybody could help me with regards to this.
> 
> Again, thanks for all the good work.

I have disabled 2nd adapter by default recently due to problems. 
Enabling 2nd FE causes driver sensitivity problems seen as mosaic pixels 
in picture. I don't know if this problem exists all devices... 2nd 
adapter can be enabled with module param, modprobe dvb-usb-af9015 
dual_mode=1 enables it. I will of course enable it by default when 
problem is found.

I did small change for GPIO setting to avoid warmboot/coldboot problem 
you have seen. Please test.
http://linuxtv.org/hg/~anttip/af9015_test

I also changed mxl5005s tuner RSSI enabled - Jose Alberto has found that 
old mxl5005 driver was using it always enabled and therefore better 
performance for his hardware.

regards
Antti
-- 
http://palosaari.fi/

_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb