Re: Wintv-1250 - EEPROM decoding - V4L DVB

[Michel Dansereau <Michel.Dansereau@videotron.ca>]

Steve,
    Point taken about dropping the mailing list.
    Thanks!
Michel

Steven Toth wrote:
> Michel Dansereau wrote:
>> Then my next question is: how different is my board from the one 
>> supported?
>> Does the analog section work at this point? Sure does not for me!
>>
>> Steven Toth wrote:
>>>>        switch (dev->board) {
>>>> /* removed        case CX23885_BOARD_HAUPPAUGE_HVR1250: */
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1500:
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1500Q:
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1400:
>>>>                if (dev->i2c_bus[0].i2c_rc == 0)
>>>>                        hauppauge_eeprom(dev, eeprom+0x80);
>>>>                break;
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1250: /*added*/
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1800:
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1800lp:
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1200:
>>>>        case CX23885_BOARD_HAUPPAUGE_HVR1700:
>>>>                if (dev->i2c_bus[0].i2c_rc == 0)
>>>>                        hauppauge_eeprom(dev, eeprom+0xc0);
>>>>                break;
>>>>        }
>>>
>>> Thanks.
>>>
>>> Hauppauge have various revs of the 1250 and the eeprom offset can 
>>> change. It looks like your model is different the the stock HVR-1250 
>>> I've seen.
>>>
>>> - Steve
>>
>
> Please don't drop the mailing list off of replies. Linux wouldn't 
> exist if we perpetuated this habit.
>
> To answer your question, no significant differences. Analog won't work 
> because I haven't done it. :)
>
> The eeprom offset is the only notable difference at this point. I'll 
> look into this, at some point.
>
> - Steve