Re: Hauppauge 2250 - second tuner is only half working

[Steven Toth <stoth@kernellabs.com>]

On 8/25/09 10:18 PM, seth@cyberseth.com wrote:
> Well my card is out the door already.  So it'll be a week or so till i can
> try again. I'll give it a pretty thorough run down when i get the new
> card, maybe I can dig up a repro.
>
> This is probably just a red herring, but FWIW I had never cold booted the
> machine (except monday morning when i yanked the card).  I warm booted
> plenty, but i frequently would run full us-Cable scan's on both tuners.
> Some time last week when repo's pushed out 2.6.28-15, i had at least one
> warm boot in there where i had the modules/firmware missing.  I
> reinstalled (dist-clean, make, make install), rebooted, and tried again
> and found it was working (well, for a little while until that spontaneous
> reboot).

Fair enough.

Another user is preparing remote access so I can take a look at the problem 
first hand. With any look we'll see the issue and have a patch by the time your 
replacement board comes back.

- Steve

-- 
Steven Toth - Kernel Labs
http://www.kernellabs.com