Re: Which modules for the VP-2033? Where is the module "mantis.ko"?

[Ruediger Dohmhardt <ruediger.dohmhardt@freenet.de>]

Manu Abraham schrieb:
> On Thu, Dec 24, 2009 at 12:01 AM, Ruediger Dohmhardt
> <ruediger.dohmhardt@freenet.de> wrote:
>   
>> Manu Abraham schrieb:
>>     
>>> Hello Ruediger,
>>>
>>> On Wed, Dec 23, 2009 at 11:04 PM, Ruediger Dohmhardt
>>> <ruediger.dohmhardt@freenet.de> wrote:
>>>
>>>       
>>>> Aljaž Prusnik schrieb:
>>>>
>>>>         
>>>>> If using the http://jusst.de/hg/v4l-dvb tree, everything compiles ok,
>>>>> module loads, but there is no remote anywhere (there is an IR folder
>>>>> with the ir-common.ko file, under common there is not).
>>>>>
>>>>>
>>>>>
>>>>>           
>>>> Aljaz, do you have the module mantis.ko?
>>>>
>>>> Ruediger
>>>>
>>>>
>>>>         
>>> There was a build issue when i posted the link originally, but it had
>>> been fixed..
>>>
>>>
>>>       
>> Yupp, it works now!
>>
>> I just downloaded version 2315248f648c. It compiles fine on Suse 11.1 and
>> it works here with vdr-1.7.10 and xineliboutput (from CVS).
>>
>> However, as Aljaž also noted, the driver does not "autoload".
>> I need to do modprobe mantis.ko.
>>
>> Manu, this used to work, but I do not remember when the "autoload was lost".
>>     
>
>
> Have you run depmod ?
>   
Yes, I did

    depmod -a

several times. Actually, if I were to miss a "depmod" than also the command

    modprobe mantis

would not work, because the module would not be found.

Ruediger