upgraded software and audio stopped working

upgraded software and audio stopped working

[James]

 It could just be coincidental that the audio stopped working after I
upgrade software.
I didn't try it right after I upgraded the system software so it could
be the hardware just failed.
I can still tune channels, I just don't get audio.

bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
bttv0: Hauppauge eeprom indicates model#44981
bttv0: tuner type=50
bttv0: audio absent, no audio device found!
tuner 2-0061: chip found @ 0xc2 (bt878 #0 [sw])

--
video4linux-list mailing list
Unsubscribe mailto:video4linux-list-request@redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list

Re: upgraded software and audio stopped working

[James]

 On 08/11/10 16:49, James wrote:
>  It could just be coincidental that the audio stopped working after I
> upgrade software.
> I didn't try it right after I upgraded the system software so it could
> be the hardware just failed.
> I can still tune channels, I just don't get audio.
>
> bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
> bttv0: Hauppauge eeprom indicates model#44981
> bttv0: tuner type=50
> bttv0: audio absent, no audio device found!
> tuner 2-0061: chip found @ 0xc2 (bt878 #0 [sw])
I upgraded the kernel and the audio out works.

bttv: driver version 0.9.18 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv 0000:02:08.0: PCI INT A -> Link[LNKA] -> GSI 17 (level, low) -> IRQ 17
bttv0: Bt878 (rev 17) at 0000:02:08.0, irq: 17, latency: 32, mmio:
0xcffff000
bttv0: detected: Hauppauge WinTV [card=10], PCI subsystem ID is 0070:13eb
bttv0: using: Hauppauge (bt878) [card=10,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init]
bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
bttv0: Hauppauge eeprom indicates model#44981
bttv0: tuner type=50
bttv0: audio absent, no audio device found!
tuner 2-0061: chip found @ 0xc2 (bt878 #0 [sw])
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: PLL can sleep, using XTAL (28636363).

--
video4linux-list mailing list
Unsubscribe mailto:video4linux-list-request@redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list