From: Hans de Goede <hdegoede@redhat.com>
To: Antti Palosaari <crope@iki.fi>
Cc: Linux Media Mailing List <linux-media@vger.kernel.org>,
hverkuil@xs4all.nl
Subject: Re: [PATCH 4/4] radio-si470x: Lower firmware version requirements
Date: Thu, 05 Jul 2012 10:33:30 +0200 [thread overview]
Message-ID: <4FF5515A.1030704@redhat.com> (raw)
In-Reply-To: <4FF45FF7.4020300@iki.fi>
Hi,
On 07/04/2012 05:23 PM, Antti Palosaari wrote:
> On 06/14/2012 04:43 PM, Hans de Goede wrote:
>> With the changes from the previous patches device firmware version 14 +
>> usb microcontroller software version 1 works fine too.
>>
>> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
>> ---
>> drivers/media/radio/si470x/radio-si470x-usb.c | 2 +-
>> drivers/media/radio/si470x/radio-si470x.h | 2 +-
>> 2 files changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/media/radio/si470x/radio-si470x-usb.c b/drivers/media/radio/si470x/radio-si470x-usb.c
>> index 66b1ba8..40b963c 100644
>> --- a/drivers/media/radio/si470x/radio-si470x-usb.c
>> +++ b/drivers/media/radio/si470x/radio-si470x-usb.c
>> @@ -143,7 +143,7 @@ MODULE_PARM_DESC(max_rds_errors, "RDS maximum block errors: *1*");
>> * Software/Hardware Versions from Scratch Page
>> **************************************************************************/
>> #define RADIO_SW_VERSION_NOT_BOOTLOADABLE 6
>> -#define RADIO_SW_VERSION 7
>> +#define RADIO_SW_VERSION 1
>> #define RADIO_HW_VERSION 1
>>
>>
>> diff --git a/drivers/media/radio/si470x/radio-si470x.h b/drivers/media/radio/si470x/radio-si470x.h
>> index fbf713d..b3b612f 100644
>> --- a/drivers/media/radio/si470x/radio-si470x.h
>> +++ b/drivers/media/radio/si470x/radio-si470x.h
>> @@ -189,7 +189,7 @@ struct si470x_device {
>> * Firmware Versions
>> **************************************************************************/
>>
>> -#define RADIO_FW_VERSION 15
>> +#define RADIO_FW_VERSION 14
>
> I just found out this patch serie and tested it - but no luck. Could you say if I do something wrong or is it due to my device firmware version?
>
I believe you're doing something wrong ...
> I compiled radio from http://git.linuxtv.org/xawtv3.git to tune and
> "arecord -r96000 -c2 -f S16_LE | aplay - " to play sound. Just silent white noise is heard.
You're not specifying which device arecord should record from so likely it is taking
the default input of your soundcard (line/mic in), rather then recording from the
radio device.
Note the latest radio from http://git.linuxtv.org/xawtv3.git will do the digital loopback of
the sound itself, so try things again with running arecord / aplay, if you then start radio
and exit again (so that you can see its startup messages) you should see something like this:
"Using alsa loopback: cap: hw:1,0 (/dev/radio0), out: default"
Note radio will automatically select the correct alsa device to record from for the radio-usb-stick.
> Jul 4 18:04:33 localhost kernel: [ 78.006361] usb 5-2: new full-speed USB device number 2 using ohci_hcd
> Jul 4 18:04:34 localhost kernel: [ 78.165127] usb 5-2: New USB device found, idVendor=10c5, idProduct=819a
> Jul 4 18:04:34 localhost kernel: [ 78.165131] usb 5-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
> Jul 4 18:04:34 localhost kernel: [ 78.165133] usb 5-2: Manufacturer: www.rding.cn
> Jul 4 18:04:34 localhost udevd[412]: specified group 'plugdev' unknown
> Jul 4 18:04:34 localhost mtp-probe: checking bus 5, device 2: "/sys/devices/pci0000:00/0000:00:13.0/usb5/5-2"
> Jul 4 18:04:34 localhost mtp-probe: bus: 5, device: 2 was not an MTP device
> Jul 4 18:04:34 localhost kernel: [ 78.189884] Linux media interface: v0.10
> Jul 4 18:04:34 localhost kernel: [ 78.191940] Linux video capture interface: v2.00
> Jul 4 18:04:34 localhost kernel: [ 78.194058] radio-si470x 5-2:1.2: DeviceID=0x1242 ChipID=0x060c
> Jul 4 18:04:34 localhost kernel: [ 78.194061] radio-si470x 5-2:1.2: This driver is known to work with firmware version 14,
> Jul 4 18:04:34 localhost kernel: [ 78.194062] radio-si470x 5-2:1.2: but the device has firmware version 12.
> Jul 4 18:04:34 localhost kernel: [ 78.196041] radio-si470x 5-2:1.2: software version 1, hardware version 7
> Jul 4 18:04:34 localhost kernel: [ 78.196043] radio-si470x 5-2:1.2: If you have some trouble using this driver,
> Jul 4 18:04:34 localhost kernel: [ 78.196045] radio-si470x 5-2:1.2: please report to V4L ML at linux-media@vger.kernel.org
> Jul 4 18:04:34 localhost kernel: [ 78.339041] usbcore: registered new interface driver radio-si470x
> Jul 4 18:04:34 localhost kernel: [ 78.357056] usbcore: registered new interface driver snd-usb-audio
>
>
> And is there any cheap USB FM-radio device that is known to work on Linux ? I would like to order one...
I've done my testing with this device:
http://www.tinydeal.com/usb-pcear-radio-recorder-for-pc-p-8603.html
And that one works, but I think yours should work fine too.
Regards,
Hans
next prev parent reply other threads:[~2012-07-05 8:33 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-06-14 13:43 [PATCH 1/4] radio-si470x: Don't unnecesarily read registers on G_TUNER Hans de Goede
2012-06-14 13:43 ` [PATCH 2/4] radio-si470x: Always use interrupt to wait for tune/seek completion Hans de Goede
2012-06-14 13:43 ` [PATCH 3/4] radio-si470x: Lower hardware freq seek signal treshold Hans de Goede
2012-06-14 13:43 ` [PATCH 4/4] radio-si470x: Lower firmware version requirements Hans de Goede
2012-07-04 15:23 ` Antti Palosaari
2012-07-05 8:33 ` Hans de Goede [this message]
2012-07-05 13:35 ` Antti Palosaari
2012-07-05 13:41 ` Hans de Goede
2012-07-05 14:13 ` Antti Palosaari
2012-07-05 15:08 ` Hans de Goede
2012-07-05 15:09 ` Antti Palosaari
2012-07-07 7:58 ` Hans de Goede
2012-07-07 9:00 ` Antti Palosaari
2012-07-07 18:53 ` Hans de Goede
2012-07-09 9:17 ` Antti Palosaari
2012-07-09 10:03 ` Hans de Goede
2012-07-09 11:58 ` Antti Palosaari
2012-07-09 13:02 ` Hans de Goede
2012-07-09 13:34 ` Antti Palosaari
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4FF5515A.1030704@redhat.com \
--to=hdegoede@redhat.com \
--cc=crope@iki.fi \
--cc=hverkuil@xs4all.nl \
--cc=linux-media@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).