Re: pctv452e

[Antti Palosaari <crope@iki.fi>]

On 07/09/2012 07:44 PM, Marx wrote:
> W dniu 2012-07-09 10:42, Antti Palosaari pisze:
>> On 07/09/2012 09:24 AM, Marx wrote:
>>> On 08.07.2012 14:32, Antti Palosaari wrote:
>>>> I suspect you stopped szap ?
>>>>
>>>> You cannot use dvbdate or dvbtraffic, nor read data from dvr0 unless
>>>> frontend is tuned. Leave szap running backround and try again.
>>>
>>> That way it works, and I can save stream. Hovewer it's strange because I
>>> shouldn't have to constatly tune channel to watch it, and on previous
>>> cards it was enough to tune once and then use other commands.
>>> I base my knowledge on
>>> http://www.linuxtv.org/wiki/index.php/Testing_your_DVB_device
>>> There is nothing about constant tuning channel to use it. Am I missing
>>> something?
>>
>> given wiki-page says:
>> "
>> 4. After you've tuned a frequency and program
>>
>> a) You could now start up your simple TV watching application and decode
>> the stream you have tuned.
>>
>> For example, while keeping {a,c,s,t}zap running in the first console
>> shell, open up another console and run
>> "
>>
>> Behavior have been always same, at least for the DVB USB.
>>
>> So you don't have problems at all?
>
> ok, my fault
> problem still exists
> VDR doesn't play any channel, and while you asked me to abandon it, I
> saved some data using
>   cat /dev/dvb/adapter0/dvr0 > /mnt/video/test3.ts
> while tuning in the background.
>
> Stream saved that way is unplayable (I play it using VLC for windows -
> it played almost all proper TS strems in the past I had). I've tried all
> software I have - to play this streams - no way.
>
> So
> - I can tune only 2/3 of channels
> - TS stream saves with errors
> - traditional tuner on the same (brand new) dish works ok
> - i've exchanged cables between the two
>
> is it possible that pctv device is less sensitive and the problem is
> with too weak signal?

If VDR does not work at all, but other tools are working, it could be 
compatibility issue between VDR and Kernel.

# tune to channel:
szap -r "CHANNEL NAME"
# dump channels from tuned multiplex (if you don't have that command 
just skip):
scandvb -c
# save tuned channel to file (lets say 20 second):
cat /dev/dvb/adapter0/dvr0 > test.ts
# check if ffmpeg finds video and audio
ffmpeg -i test.ts

and post result here

regards
Antti

-- 
http://palosaari.fi/