Re: [RFC][PATCH] rtl2832: PID filter support for slave demod

[Benjamin Larsson <benjamin@southpole.se>]

On 03/16/2015 11:57 PM, Antti Palosaari wrote:
> On 03/17/2015 12:12 AM, Benjamin Larsson wrote:
>> Is this structure ok for the slave pid implementation? Or should there
>> be only one filters parameter? Will the overlaying pid filter framework
>> properly "flush" the set pid filters ?
>>
>> Note that this code currently is only compile tested.
>
> I am fine with it.
>
> byw. Have you tested if your QAM256 (DVB-C or DVB-T2) stream is valid
> even without a PID filtering? IIRC mine stream is correct and PID
> filtering is not required (but surely it could be implemented if you wish).
>
> regards
> Antti
>

DVB-C seems fine and one of my DVB-T2 muxes is fine also. But one other 
DVB-T2 mux completely fails. It could be the reception but it might be 
that it needs pid filtering. I do get small disturbances on my DVB-C 
muxes. Will report back if pid filtering makes things better or not.

MvH
Benjamin Larsson