Re: MCE TV Philips 7135 Cardbus don't work

From: Marc Randolph <mrandtx@yahoo.com>
To: Emilio Lazo Zaia <emiliolazozaia@gmail.com>, video4linux-list@redhat.com
Subject: Re: MCE TV Philips 7135 Cardbus don't work
Date: Tue, 29 Apr 2008 16:20:10 -0700 (PDT)	[thread overview]
Message-ID: <88771.83842.qm@web83107.mail.mud.yahoo.com> (raw)
In-Reply-To: <1209492450.16986.31.camel@localhost.localdomain>

--- Emilio Lazo Zaia <emiliolazozaia@gmail.com> wrote:

> Hello,
> 
> I have purchased a "MCE TV Philips 7135 Cardbus" and I'm to set it up.
> When I plug it, the module saa7134 is being loaded and dmesg says:
> 
> ï»¿pccard: CardBus card inserted into slot 0
> Linux video capture interface: v2.00
> saa7130/34: v4l2 driver version 0.2.14 loaded
> PCI: Enabling device 0000:06:00.0 (0000 -> 0002)
> ACPI: PCI Interrupt 0000:06:00.0[A] -> GSI 17 (level, low) -> IRQ 17
> saa7133[0]: found at 0000:06:00.0, rev: 209, irq: 17, latency: 0, mmio:
> 0x54000000
> PCI: Setting latency timer of device 0000:06:00.0 to 64
> saa7133[0]: subsystem: 1131:0000, board: UNKNOWN/GENERIC
> [card=0,autodetected]
> saa7133[0]: board init: gpio is e2c0c0
> saa7133[0]: Huh, no eeprom present (err=-5)?
> saa7133[0]: registered device video0 [v4l2]
> saa7133[0]: registered device vbi0

Howdy Emilio,

Google gives a ton of hits on that very unique error message.  I assume you
already did this:

"try to pass newi2c=1 or newi2c=0 to the ivtv module. Add it to
/etc/modprobe.conf (or /etc/modules.d/ivtv if you are an gentoo user).

options ivtv newi2c=1

If setting this works please report it to the ivtv-devel mailing list."

Copied from
http://ivtvdriver.org/index.php/Troubleshooting#Error:_Huh.2C_no_eeprom_present_.28err.3D-121.29.3F

Good luck,

   Marc

--
video4linux-list mailing list
Unsubscribe mailto:video4linux-list-request@redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list