messages from 2026-10-20 15:36:47 to 2026-10-20 21:15:12 UTC [more...]
[PATCH 0/7] phy: qcom-mipi-csi2: Add D-PHY support for sa8775p, qcs8300 and sc7280
2026-10-20 21:15 UTC (12+ messages)
` [PATCH 3/7] dt-bindings: phy: qcom: Add qcs8300 to the CSI2 PHY schema
` [PATCH 5/7] phy: qcom-mipi-csi2: Add qcs8300 CSI2 PHY support
` [PATCH 2/7] dt-bindings: phy: qcom: Add qcom,sa8775p-csi2-phy schema
[PATCH 0/2] media: qcom: iris: Fix IRQ synchronization during power-off
2026-10-20 21:00 UTC (3+ messages)
` [PATCH 2/2] media: qcom: iris: Wait for threaded IRQ completion "
[PATCH] media: qcom: iris: fix PAS ID passed to set_remote_state
2026-10-20 20:45 UTC
[PATCH 0/2] i2c: qcom-cci: Recover after a target powers down under a running controller
2026-10-20 19:39 UTC (3+ messages)
` [PATCH 1/2] i2c: qcom-cci: Reset the controller when it resumes
` [PATCH 2/2] i2c: qcom-cci: Suspend the controller 50 ms after the last transfer
[PATCH net v4 0/4] net: devmem: fix RX and TX binding teardown on device unregistration
2026-10-20 19:18 UTC (4+ messages)
` [PATCH net v4 3/4] netdevsim: support devmem RX and TX bindings
[PATCH] media: chips-media: wave5: Fix possible ERR_PTR deference
2026-10-20 19:16 UTC (5+ messages)
[RFC PATCH 0/6] iommufd: harden DMA-BUF PAL setup and release
2026-10-20 18:20 UTC (3+ messages)
[PATCH 0/4] media: Add the ST VD55G0 global shutter sensor
2026-10-20 18:14 UTC (10+ messages)
` [PATCH 2/4] media: i2c: Add ST VD55G0 global shutter sensor driver
dvb_usb_v2: frontend kthread wedges in dvb_usb_fe_sleep, taking down the USB bus and machine shutdown (DVBSky S960)
2026-10-20 16:18 UTC (2+ messages)
[PATCH 0/4] media: rcar-isp: Add NV12M support and fix stride
2026-10-20 15:51 UTC (6+ messages)
` [PATCH 1/4] media: rcar-isp: ispcore: Honour requested bytesperline on RAW input
[RFC PATCH v2 0/3] Solve dma_fence's problems by locking
2026-10-20 15:36 UTC (5+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox