Re: [PATCH 0/2] Some small preparations around CAMSS D-PHY / C-PHY support

[Bryan O'Donoghue <bryan.odonoghue@linaro.org>]

On 26/02/2025 14:13, Luca Weiss wrote:
> Hi all,
> 
> On Mon Dec 9, 2024 at 1:01 PM CET, Luca Weiss wrote:
>> Since the hardware blocks on the SoCs generally support both D-PHY and
>> C-PHY standards for camera, but the camss driver currently is only
>> supporting D-PHY, do some preparations in order to add C-PHY support at
>> some point.
>>
>> Make the dt bindings explicit that the hardware supports both (except
>> for MSM8916) but also add a check to the driver that errors out in case
>> a dt tries to use C-PHY since that's not supported yet.
>>
>> Signed-off-by: Luca Weiss <luca.weiss@fairphone.com>
>> ---
>> Luca Weiss (2):
>>        media: dt-bindings: media: camss: Restrict bus-type property
>>        media: qcom: camss: Restrict endpoint bus-type to D-PHY
> 
> This series is still pending, both patches got reviews and no pending
> comments from what I can see.
> 
> Would be nice to get it in for 6.15.
> 
Yes this should be merged.

Thanks for following up.

---
bod