From: Philipp Zabel <p.zabel@pengutronix.de>
To: Rob Herring <robh@kernel.org>
Cc: Mark Rutland <mark.rutland@arm.com>,
devicetree@vger.kernel.org, Paul Bolle <pebolle@tiscali.nl>,
YT Shen <yt.shen@mediatek.com>,
Jitao Shi <jitao.shi@mediatek.com>,
Jie Qiu <jie.qiu@mediatek.com>, Pawel Moll <pawel.moll@arm.com>,
Ian Campbell <ijc+devicetree@hellion.org.uk>,
Cawa Cheng <cawa.cheng@mediatek.com>,
dri-devel@lists.freedesktop.org,
linux-mediatek@lists.infradead.org,
Kumar Gala <galak@codeaurora.org>,
Matthias Brugger <matthias.bgg@gmail.com>,
kernel@pengutronix.de
Subject: Re: [RFC v5 01/12] dt-bindings: drm/mediatek: Add Mediatek display subsystem dts binding
Date: Thu, 05 Nov 2015 15:59:30 +0100 [thread overview]
Message-ID: <1446735570.3894.105.camel@pengutronix.de> (raw)
In-Reply-To: <20151105032806.GA4368@rob-hp-laptop>
Am Mittwoch, den 04.11.2015, 21:28 -0600 schrieb Rob Herring:
> On Wed, Nov 04, 2015 at 12:44:58PM +0100, Philipp Zabel wrote:
> > From: CK Hu <ck.hu@mediatek.com>
> >
> > Add device tree binding documentation for the display subsystem in
> > Mediatek MT8173 SoCs.
> >
> > Signed-off-by: CK Hu <ck.hu@mediatek.com>
> > Signed-off-by: Philipp Zabel <p.zabel@pengutronix.de>
>
> If this wasn't an RFC, I'd ack it. :) One thing you missed below though.
Alright, thanks for your help in sorting these bindings out.
[...]
> > diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,disp.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,disp.txt
> > new file mode 100644
> > index 0000000..cc3d884
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,disp.txt
[...]
> > +DISP function blocks
> > +====================
> > +
> > +A display stream starts at a source function block that reads pixel data from
> > +memory and ends with a sink function block that drives pixels on a display
> > +interface, or writes pixels back to memory. All DISP function blocks have
> > +their own register space, interrupt, and clock gate. The blocks that can
> > +access memory additionally have to list the IOMMU and local arbiter they are
> > +connected to.
> > +
> > +For a description of the display interface sink function blocks, see
> > +Documentation/devicetree/bindings/drm/mediatek/mediatek,dsi.txt and
> > +Documentation/devicetree/bindings/drm/mediatek/mediatek,dpi.txt.
>
> Need to update these paths.
Will do.
regards
Philipp
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/dri-devel
next prev parent reply other threads:[~2015-11-05 14:59 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-04 11:44 [RFC v5 00/12] MT8173 DRM support Philipp Zabel
2015-11-04 11:44 ` [RFC v5 01/12] dt-bindings: drm/mediatek: Add Mediatek display subsystem dts binding Philipp Zabel
2015-11-05 3:28 ` Rob Herring
2015-11-05 14:59 ` Philipp Zabel [this message]
2015-11-04 11:44 ` [RFC v5 02/12] drm/mediatek: Add DRM Driver for Mediatek SoC MT8173 Philipp Zabel
2015-11-04 18:49 ` Daniel Kurtz
2015-11-05 14:55 ` Philipp Zabel
2015-11-04 11:45 ` [RFC v5 03/12] drm/mediatek: Add DSI sub driver Philipp Zabel
2015-11-04 11:45 ` [RFC v5 05/12] dt-bindings: drm/mediatek: Add Mediatek HDMI dts binding Philipp Zabel
2015-11-05 3:31 ` Rob Herring
2015-11-04 11:45 ` [RFC v5 06/12] drm/mediatek: Add HDMI support Philipp Zabel
2015-11-04 11:45 ` [RFC v5 08/12] arm64: dts: mt8173: Add display subsystem related nodes Philipp Zabel
2015-11-04 11:45 ` [RFC v5 09/12] arm64: dts: mt8173: Add HDMI " Philipp Zabel
[not found] ` <1446637509-6418-1-git-send-email-p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
2015-11-04 11:45 ` [RFC v5 04/12] drm/mediatek: Add DPI sub driver Philipp Zabel
2015-11-04 11:45 ` [RFC v5 07/12] drm/mediatek: enable hdmi output control bit Philipp Zabel
2015-11-04 11:45 ` [RFC v5 10/12] clk: mediatek: make dpi0_sel and hdmi_sel not propagate rate changes Philipp Zabel
2015-11-04 11:45 ` [RFC v5 11/12] clk: mediatek: Add hdmi_ref HDMI PHY PLL reference clock output Philipp Zabel
2015-11-04 11:45 ` [RFC v5 12/12] dt-bindings: hdmi-connector: add DDC I2C bus phandle documentation Philipp Zabel
2015-11-05 3:34 ` Rob Herring
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1446735570.3894.105.camel@pengutronix.de \
--to=p.zabel@pengutronix.de \
--cc=cawa.cheng@mediatek.com \
--cc=devicetree@vger.kernel.org \
--cc=dri-devel@lists.freedesktop.org \
--cc=galak@codeaurora.org \
--cc=ijc+devicetree@hellion.org.uk \
--cc=jie.qiu@mediatek.com \
--cc=jitao.shi@mediatek.com \
--cc=kernel@pengutronix.de \
--cc=linux-mediatek@lists.infradead.org \
--cc=mark.rutland@arm.com \
--cc=matthias.bgg@gmail.com \
--cc=pawel.moll@arm.com \
--cc=pebolle@tiscali.nl \
--cc=robh@kernel.org \
--cc=yt.shen@mediatek.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox