[RESEND PATCH 4/5] usb: mtu3: fix operation failure when test TEST_J/K

Chunfeng Yun
2018-05-05T02:21:19Z

There is an error dialog popped up in PC when test TEST_J/K
by EHSETT tool, due to not waiting for the completion of
control transfer. Here fix it by entering test mode after
Status Stage finish.

Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
---
drivers/usb/mtu3/mtu3_gadget_ep0.c | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/drivers/usb/mtu3/mtu3_gadget_ep0.c b/drivers/usb/mtu3/mtu3_gadget_ep0.c
index d67b540..0d2b1cf 100644
--- a/drivers/usb/mtu3/mtu3_gadget_ep0.c
+++ b/drivers/usb/mtu3/mtu3_gadget_ep0.c
@@ -7,6 +7,7 @@
* Author: Chunfeng.Yun <chunfeng.yun@mediatek.com>
*/

+#include <linux/iopoll.h>
#include <linux/usb/composite.h>

#include "mtu3.h"
@@ -263,6 +264,7 @@ static int handle_test_mode(struct mtu3 *mtu, struct usb_ctrlrequest *setup)
{
void __iomem *mbase = mtu->mac_base;
int handled = 1;
+ u32 value;

switch (le16_to_cpu(setup->wIndex) >> 8) {
case TEST_J:
@@ -292,6 +294,14 @@ static int handle_test_mode(struct mtu3 *mtu, struct usb_ctrlrequest *setup)
if (mtu->test_mode_nr == TEST_PACKET_MODE)
ep0_load_test_packet(mtu);

+ /* send status before entering test mode. */
+ value = mtu3_readl(mbase, U3D_EP0CSR) & EP0_W1C_BITS;
+ mtu3_writel(mbase, U3D_EP0CSR, value | EP0_SETUPPKTRDY | EP0_DATAEND);
+
+ /* wait for ACK status sent by host */
+ readl_poll_timeout(mbase + U3D_EP0CSR, value,
+ !(value & EP0_DATAEND), 100, 5000);
+
mtu3_writel(mbase, U3D_USB2_TEST_MODE, mtu->test_mode_nr);

mtu->ep0_state = MU3D_EP0_STATE_SETUP;
--
1.9.1