[PATCH v5 0/4] Add driver nodes for MT8192 SoC

Allen-KH Cheng
2022-03-30T13:38:36Z

Add driver nodes for MT8192 SoC and this series are based on matthias.bgg/linux.git, v5.18-next/dts64
(PCIe, mmc, H264 venc, vcodec lat and core nodes)

In order to track the dependencies of some patches, I remove them from this series and will
send a new series for each node. (spmi, gce, infracfg_rst, mipi_tx, dpi, display, dsi, gce info and pwm)

changes since v4:
- remove some patches from this series.
- PCIe: remove reset node, correct the clk names
- mmc: reserve msdc node
- vcodec: correct the clk names (remove vdec- prefix)

changes since v3:
- add patch: add the mmsys reset bit to reset the dsi0
- dsi0: use mmsys for reset controller support
- mmc: reorder clocks as specified in the dt-bindings
- vcodec: use ranges for regs of subnodes

changes since v2:
- rebase on next-20220304
- remove power domains controller patch from series (already in linux-next)
- scp: fix indentation
- t-phy: change node name from usb-phy to t-phy and set ranges address
- usb: change node name from xhci to usb and add disabled status
- audsys: syscon: add increasing the address range's length info in commit message
- infracfg_rst: add simple-mfd info in commit message
- nor_flash: add Fixes tag d0a197a0d064a in commit message
- efuse: use lower case characters
- mmc: use single line for reg
- mipi_tx: change node name from mipi-dphy to dsi-phy, drop clock-names and add disabled status
- m4u and smi: fixing the formatting of the mediatek,larbs properties and remove smi-id property
- H264 venc: fix indentation, remove '0x' prefix for node address
- vcodec lat and core: use '-' instead of '_' in the node name, fix indentation and
set mtk-vcodec-lat and mtk-vcodec-core as subnodes of vcodec-dec
- dpi: add disabled status
- display: appended "mediatek,mt8183-disp-aal" for ccorr
- dsi: fix indentation and add disabled status
- gce info: add drivers' CMDQ support inn commit message
- pwm: add disabled status
- i2c aliases: move the aliases at the board level.

changes since v1:
- add usb-phy node for xhci node
- move infracfg_rst patch in front of PCIe patch
- add display nodes, i2c aliases and pwm node.

Allen-KH Cheng (4):
arm64: dts: mt8192: Add PCIe node
arm64: dts: mt8192: Add mmc device nodes
arm64: dts: mt8192: Add H264 venc device node
arm64: dts: mt8192: Add vcodec lat and core nodes

arch/arm64/boot/dts/mediatek/mt8192.dtsi | 150 +++++++++++++++++++++++
1 file changed, 150 insertions(+)

--
2.18.0