Re: mt1873-evb: MMC failing with linux-next

[Matthias Brugger <matthias.bgg@gmail.com>]

Hi,

I just resend as the attachment was to too big for linux-arm-kernel.

On 12/02/16 16:24, Matthias Brugger wrote:
> Hi Kevin,
>
> On 09/02/16 02:18, Kevin Hilman wrote:
>> Hello,
>>
>> I tried getting MMC working with linux-next (next-20160208) on
>> mt8173-evb by enabling a few options[1] on top of the default defconfig,
>> and this results in a kernel that hangs as soon as it starts userspace.
>>
>> The MMC driver seems to start, though has some regulator issues:
>>
>> [    0.526380] sdhci: Secure Digital Host Controller Interface driver
>> [    0.527176] sdhci: Copyright(c) Pierre Ossman
>> [    0.528835] vio18: unsupportable voltage range: 3300000-1980000uV
>> [    0.529610] mtk-msdc 11230000.mmc: Regulator set error -22:
>> 3300000 - 3300000
>> [    0.563731] mtk-msdc 11240000.mmc: Got CD GPIO
>>
>> The driver appears to be attempting to set 3.3V but using a 1.8V
>> regulator (vio18), which is failing.
>>
>> Then, the kernel hangs after freeing unused memory:
>>
>> [    0.616386] hctosys: unable to open rtc device (rtc0)
>> [    0.624118] usb_vbus: disabling
>> [    0.624547] vusb: disabling
>> [    0.624929] vgp6: disabling
>> [    0.625635] ALSA device list:
>> [    0.626009]   No soundcards found.
>> [    0.626963] Freeing unused kernel memory: 724K (ffffffc000977000 -
>> ffffffc000a2c000)
>>
>> And nothing further here.
>>
>
> I can see the warning from the mmc regulator access, but after that my
> board boots just fine.
> I'm using linux-next as of today (20160212).
> I attached my config, it should be defconfig plus the config options you
> mentioned (and an initramfs).
>

Instead of attaching my config, you can find it here:
http://pastebin.com/5uhXtSHj

> Is this the configuration you have?
>
> Regards,
> Matthias
>
>> It boots fine when disabling the MMC driver (CONFIG_MMC_MTK=n).
>>
>> Any ideas?
>>
>> Kevin
>>
>> [1]
>> CONFIG_MMC_MTK=y
>> CONFIG_MFD_MT6397=y
>> CONFIG_REGULATOR_MT6397=y
>> CONFIG_MTK_PMIC_WRAP=y
>>