[PATCH net-next v2 4/5] net: phylink: use neg_mode in phylink_mii_c22_pcs_decode_state()

["Russell King (Oracle)" <rmk+kernel@armlinux.org.uk>]

Rather than using the state of the Autoneg bit, which is unreliable
with the new PCS neg mode support, use the passed neg_mode to decide
whether to decode the link partner advertisement data.

Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
---
 drivers/net/phy/phylink.c | 12 ++++++++----
 1 file changed, 8 insertions(+), 4 deletions(-)

diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
index b29b7e73b5bd..b79f975bc164 100644
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -3877,11 +3877,15 @@ void phylink_mii_c22_pcs_decode_state(struct phylink_link_state *state,
 {
 	state->link = !!(bmsr & BMSR_LSTATUS);
 	state->an_complete = !!(bmsr & BMSR_ANEGCOMPLETE);
-	/* If there is no link or autonegotiation is disabled, the LP advertisement
-	 * data is not meaningful, so don't go any further.
+
+	/* If the link is down, the advertisement data is undefined. */
+	if (!state->link)
+		return;
+
+	/* If in-band is disabled, then the advertisement data is not
+	 * meaningful.
 	 */
-	if (!state->link || !linkmode_test_bit(ETHTOOL_LINK_MODE_Autoneg_BIT,
-					       state->advertising))
+	if (neg_mode != PHYLINK_PCS_NEG_INBAND_ENABLED)
 		return;
 
 	switch (state->interface) {
-- 
2.30.2