Re: [PATCH v2] net: mtk_sgmii: implement mtk_pcs_ops

["Russell King (Oracle)" <linux@armlinux.org.uk>]

On Mon, Jan 16, 2023 at 05:45:12PM +0100, Bjørn Mork wrote:
> Bjørn Mork <bjorn@mork.no> writes:
> 
> >> You have bmcr=0x1000, but the code sets two bits - SGMII_AN_RESTART and
> >> SGMII_AN_ENABLE which are bits 9 and 12, so bmcr should be 0x1200, not
> >> 0x1000. Any ideas why?
> >
> > No, not really
> 
> Doh! Looked over it again, and this was my fault of course.  Had an
> 
>   "bmcr = SGMII_AN_ENABLE;"
>   
> line overwriting the original value from a previous attempt without
> changing the if condition.. Thanks for spotting that.
> 
> But this still doesn't work any better:
> 
> [   43.019395] mtk_soc_eth 15100000.ethernet wan: Link is Down
> [   45.099898] mtk_sgmii_select_pcs: id=1
> [   45.103653] mtk_pcs_config: interface=4
> [   45.107473] offset:0 0x140
> [   45.107476] offset:4 0x4d544950
> [   45.110181] offset:8 0x20
> [   45.113305] forcing AN
> [   45.118256] mtk_pcs_config: rgc3=0x0, advertise=0x1 (changed), link_timer=1600000,  sgm_mode=0x103, bmcr=0x1200, use_an=1
> [   45.129191] mtk_pcs_link_up: interface=4
> [   45.133100] offset:0 0x81140
> [   45.133102] offset:4 0x4d544950
> [   45.135967] offset:8 0x1
> [   45.139104] mtk_soc_eth 15100000.ethernet wan: Link is Up - 1Gbps/Full - flow control rx/tx

In your _dump_pcs_ctrl() function, please can you dump the
SGMSYS_SGMII_MODE register as well (offset 0x20), in case this gives
more clue as to what's going on.

Thanks.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!