Re: [PATCH v5 3/6] dt-bindings: mfd: Add Realtek RTL9300 switch peripherals

[Lee Jones <lee@kernel.org>]

Intentional top-post.

These replies all came in without the original mail.

Does anyone have any idea why that would have been?

On Thu, 26 Sep 2024, Krzysztof Kozlowski wrote:

> On Thu, Sep 26, 2024 at 09:58:44AM +1200, Chris Packham wrote:
> > Add device tree schema for the Realtek RTL9300 switches. The RTL9300
> > family is made up of the RTL9301, RTL9302B, RTL9302C and RTL9303. These
> > have the same SoC differ in the Ethernet switch/SERDES arrangement.
> > 
> > Currently the only supported features are the syscon-reboot and i2c
> > controllers. The syscon-reboot is needed to be able to reboot the board.
> > The I2C controllers are slightly unusual because they each own an SCL
> > pin (GPIO8 for the first controller, GPIO 17 for the second) but have 8
> > common SDA pins which can be assigned to either controller (but not
> > both).
> > 
> > Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
> > ---
> > 
> > Notes:
> >     Changes in v5:
> >       I've combined the two series I had in flight so this is the
> >       combination of adding the switch syscon, the reboot and i2c. It makes
> >       the changelog a bit meaningless so I've dropped the earlier
> >       commentary.
> >     
> >       As requested I've put a more complete example in the main
> >       rtl9300-switch.yaml.
> >     
> >       I've kept rtl9300-i2c.yaml separate for now but link to it with a $ref
> >       from rtl9300-switch.yaml to reduce clutter. The example in
> >       rtl9300-i2c.yaml is technically duplicating part of the example from
> >       rtl9300-switch.yaml but I feel it's nice to be able to see the example
> >       next to where the properties are defined.
> 
> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> 
> Best regards,
> Krzysztof
> 

-- 
Lee Jones [李琼斯]