[PATCH net-next 5/5] mips: dts: cameo-rtl9302c: Add switch block

[Chris Packham <chris.packham@alliedtelesis.co.nz>]

Add the switch port and phys to the cameo-rtl9302c-2x-rtl8224-2xge
board.

Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
---

Notes:
    This is technically v7 of [1]. Differences from that are that I've
    omitted the MDIO busses and PHYs while I'm trying to sort out the switch
    bindings. I'll add these back in a follow up series.
    
    [1] - https://lore.kernel.org/lkml/20250204030249.1965444-7-chris.packham@alliedtelesis.co.nz/

 .../cameo-rtl9302c-2x-rtl8224-2xge.dts        | 48 +++++++++++++++++++
 1 file changed, 48 insertions(+)

diff --git a/arch/mips/boot/dts/realtek/cameo-rtl9302c-2x-rtl8224-2xge.dts b/arch/mips/boot/dts/realtek/cameo-rtl9302c-2x-rtl8224-2xge.dts
index 6789bf374044..51306c104b01 100644
--- a/arch/mips/boot/dts/realtek/cameo-rtl9302c-2x-rtl8224-2xge.dts
+++ b/arch/mips/boot/dts/realtek/cameo-rtl9302c-2x-rtl8224-2xge.dts
@@ -71,3 +71,51 @@ partition@1180000 {
 		};
 	};
 };
+
+&switch0 {
+	ethernet-ports {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		port@0 {
+			reg = <0>;
+			phy-mode = "usxgmii";
+		};
+		port@1 {
+			reg = <1>;
+			phy-mode = "usxgmii";
+		};
+		port@2 {
+			reg = <2>;
+			phy-mode = "usxgmii";
+		};
+		port@3 {
+			reg = <3>;
+			phy-mode = "usxgmii";
+		};
+		port@16 {
+			reg = <16>;
+			phy-mode = "usxgmii";
+		};
+		port@17 {
+			reg = <17>;
+			phy-mode = "usxgmii";
+		};
+		port@18 {
+			reg = <18>;
+			phy-mode = "usxgmii";
+		};
+		port@19 {
+			reg = <19>;
+			phy-mode = "usxgmii";
+		};
+		port@24{
+			reg = <24>;
+			phy-mode = "10gbase-r";
+		};
+		port@25{
+			reg = <25>;
+			phy-mode = "10gbase-r";
+		};
+	};
+};
-- 
2.48.1