[PATCH][MIPS] Malta: Fix reading the PCI clock frequency on big-endian

[Dmitri Vorobiev <dmitri.vorobiev@gmail.com>]

The JMPRS register on Malta boards keeps a 32-bit CPU-endian
value. The readw() function assumes that the value it reads is a
little-endian 16-bit number. Therefore, using readw() to obtain
the value of the JMPRS register is a mistake. This error leads
to incorrect reading of the PCI clock frequency on big-endian
during board start-up.

Change readw() to __raw_readl().

This was tested by injecting a call to printk() and verifying
that the value of the jmpr variable was consistent with current
setting of the JP4 "PCI CLK" jumper.

Signed-off-by: Dmitri Vorobiev <dmitri.vorobiev@gmail.com>
---
 arch/mips/mips-boards/malta/malta_setup.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/arch/mips/mips-boards/malta/malta_setup.c b/arch/mips/mips-boards/malta/malta_setup.c
index 9a2636e..bc43a5c 100644
--- a/arch/mips/mips-boards/malta/malta_setup.c
+++ b/arch/mips/mips-boards/malta/malta_setup.c
@@ -149,7 +149,7 @@ void __init plat_mem_setup(void)
 	/* Check PCI clock */
 	{
 		unsigned int __iomem *jmpr_p = (unsigned int *) ioremap(MALTA_JMPRS_REG, sizeof(unsigned int));
-		int jmpr = (readw(jmpr_p) >> 2) & 0x07;
+		int jmpr = (__raw_readl(jmpr_p) >> 2) & 0x07;
 		static const int pciclocks[] __initdata = {
 			33, 20, 25, 30, 12, 16, 37, 10
 		};
-- 
1.5.3