Re: [PATCH] staging/octeon: Fix PHY binding in octeon-ethernet driver.

[Florian Fainelli <florian@openwrt.org>]

Le 02/23/12 20:19, David Daney a écrit :
> From: David Daney<david.daney@cavium.com>
>
> Commit d6c25be (mdio-octeon: use an unique MDIO bus name.) changed the
> names used to refer to MDIO buses.  The ethernet driver must be
> changed to match, so that the PHY drivers can be attached.
>
> Cc: Florian Fainelli<florian@openwrt.org>
> Signed-off-by: David Daney<david.daney@cavium.com>
Acked-by: Florian Fainelli <florian@openwrt.org>
> ---
>   drivers/staging/octeon/ethernet-mdio.c |    4 ++--
>   1 files changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/staging/octeon/ethernet-mdio.c b/drivers/staging/octeon/ethernet-mdio.c
> index 63800ba..e31949c 100644
> --- a/drivers/staging/octeon/ethernet-mdio.c
> +++ b/drivers/staging/octeon/ethernet-mdio.c
> @@ -164,9 +164,9 @@ int cvm_oct_phy_setup_device(struct net_device *dev)
>
>   	int phy_addr = cvmx_helper_board_get_mii_address(priv->port);
>   	if (phy_addr != -1) {
> -		char phy_id[20];
> +		char phy_id[MII_BUS_ID_SIZE + 3];
>
> -		snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT, "0", phy_addr);
> +		snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT, "mdio-octeon-0", phy_addr);
>
>   		priv->phydev = phy_connect(dev, phy_id, cvm_oct_adjust_link, 0,
>   					PHY_INTERFACE_MODE_GMII);