Linux MIPS Architecture development
 help / color / mirror / Atom feed
 messages from 2012-08-04 16:02:36 to 2012-08-17 08:48:08 UTC [more...]

[PATCH V6 00/16] MIPS: Add Loongson-3 based machines support
 2012-08-17  8:43 UTC  (11+ messages)
` [PATCH V6 01/15] MIPS: Loongson: Add basic Loongson-3 definition
` [PATCH V6 02/15] MIPS: Loongson: Add basic Loongson-3 CPU support
` [PATCH V6 03/15] MIPS: Loongson: Introduce and use cpu_has_coherent_cache feature
` [PATCH V6 04/15] MIPS: Loongson 3: Add Lemote-3A machtypes definition
` [PATCH V6 05/15] MIPS: Loongson: Add UEFI-like firmware interface support
` [PATCH V6 06/15] MIPS: Loongson 3: Add HT-linked PCI support
` [PATCH V6 07/15] MIPS: Loongson 3: Add IRQ init and dispatch support
` [PATCH V6 08/15] MIPS: Loongson 3: Add serial port support
` [PATCH V6 09/15] MIPS: Loongson: Add swiotlb to support big memory (>4GB)
` [PATCH V6 10/15] MIPS: Loongson: Add Loongson-3 Kconfig options

[PATCH v2 0/3] MIPS: BCM47xx: use gpiolib
 2012-08-16 22:38 UTC  (12+ messages)
` [PATCH v2 1/3] ssb: add function to return number of gpio lines
` [PATCH v2 2/3] bcma: add GPIO driver for SoCs
` [PATCH v2 3/3] MIPS: BCM47xx: rewrite GPIO handling and use gpiolib

[PATCH v3 0/7] Avoid cache trashing on clearing huge/gigantic page
 2012-08-16 19:42 UTC  (13+ messages)
` [PATCH v3 1/7] THP: Use real address for NUMA policy
` [PATCH v3 2/7] THP: Pass fault address to __do_huge_pmd_anonymous_page()
` [PATCH v3 3/7] hugetlb: pass fault address to hugetlb_no_page()
` [PATCH v3 4/7] mm: pass fault address to clear_huge_page()
` [PATCH v3 5/7] x86: Add clear_page_nocache
` [PATCH v3 6/7] mm: make clear_huge_page cache clear only around the fault address
` [PATCH v3 7/7] x86: switch the 64bit uncached page clear to SSE/AVX v2

[PATCH] MIPS: Optimize pgd_init and pmd_init
 2012-08-16 18:15 UTC 

[PATCH V2 1/4] MIPS: lantiq: adds support for nmi and ejtag bootrom vectors
 2012-08-16 12:39 UTC  (2+ messages)
` [PATCH V2 1/4] MIPS: lantiq: split up IRQ IM ranges

[PATCH] MIPS: lantiq: adds support for gptu timers
 2012-08-16 12:31 UTC 

[PATCH] MIPS: fix module.c build for 32 bit
 2012-08-16 10:40 UTC  (12+ messages)
      ` [PATCH] MIPS: Fix "

[PATCH] I2C: MIPS: lantiq: add FALC-ON i2c bus master
 2012-08-16  9:40 UTC  (4+ messages)

[PATCH 1/4] MIPS: lantiq: adds support for nmi and ejtag bootrom vectors
 2012-08-16  9:25 UTC  (4+ messages)
` [PATCH 2/4] MIPS: lantiq: explicitly enable clkout generation
` [PATCH 3/4] MIPS: lantiq: falcon clocks were not enabled properly
` [PATCH 4/4] MIPS: lantiq: enable pci clk conditional for xrx200 SoC

[PATCH 1/4] MIPS: lantiq: split up IRQ IM ranges
 2012-08-16  9:09 UTC  (4+ messages)
` [PATCH 2/4] MIPS: lantiq: timer irq can be different to 7
` [PATCH 3/4] MIPS: lantiq: dont register irq_chip for the irq cascade
` [PATCH 4/4] MIPS: lantiq: external irq sources are not loaded properly

[PATCH] SPI: MIPS: lantiq: adds spi-xway
 2012-08-16  7:57 UTC 

[PATCH V2] MIPS: Fix poweroff failure when HOTPLUG_CPU configured
 2012-08-16  3:47 UTC  (4+ messages)

[PATCH V5 00/16] MIPS: Add Loongson-3 based machines support
 2012-08-16  3:20 UTC  (41+ messages)
` [PATCH V5 01/18] MIPS: Loongson: Add basic Loongson-3 definition
` [PATCH V5 02/18] MIPS: Loongson: Add basic Loongson-3 CPU support
` [PATCH V5 03/18] MIPS: Loongson 3: Add Lemote-3A machtypes definition
` [PATCH V5 04/18] MIPS: Loongson: Make Loongson-3 to use BCD format for RTC
` [PATCH V5 05/18] MIPS: Loongson: Add UEFI-like firmware interface support
` [PATCH V5 06/18] MIPS: Loongson 3: Add HT-linked PCI support
` [PATCH V5 07/18] MIPS: Loongson 3: Add IRQ init and dispatch support
` [PATCH V5 08/18] MIPS: Loongson 3: Add serial port support
` [PATCH V5 09/18] MIPS: Loongson: Add swiotlb to support big memory (>4GB)
` [PATCH V5 10/18] MIPS: Loongson: Add Loongson-3 Kconfig options
` [PATCH V5 11/18] drm/radeon: Include swiotlb.h if SWIOTLB configured
` [PATCH V5 12/18] drm: Handle io prot correctly for MIPS
` [PATCH V5 13/18] drm: Define SAREA_MAX for Loongson (PageSize = 16KB)
` [PATCH V5 14/18] ALSA: HDA: Make hda sound card usable for Loongson
  ` [alsa-devel] "
` [PATCH V5 15/18] MIPS: Loongson 3: Add Loongson-3 SMP support
` [PATCH V5 16/18] MIPS: Loongson 3: Add CPU hotplug support
` [PATCH V5 17/18] MIPS: Fix poweroff failure when HOTPLUG_CPU configured
` [PATCH V5 18/18] MIPS: Loongson: Add a Loongson-3 default config file

[PATCH 0/2] MIPS: Netlogic: Fixes for 3.6
 2012-08-15 17:42 UTC  (7+ messages)
` [PATCH 1/2] MIPS: Netlogic: define cpu_has_fpu macro
    ` [PATCH] MIPS: Fix for warning from FPU emulation code
` [PATCH 2/2] MIPS: Synchronize MIPS count one CPU at a time

[PATCH] MIPS: add default configuration for ath79
 2012-08-15 12:00 UTC  (3+ messages)

[PATCH 0/2] Align MIPS swapper_pg_dir for faster code
 2012-08-15 10:57 UTC  (5+ messages)
` [PATCH 1/2] vmlinux.lds.h: Allow architectures to add sections to the front of .bss
` [PATCH 2/2] MIPS: Align swapper_pg_dir to 64K for better TLB Refill code

[PATCH] MIPS: ath79: don't hardcode the unavailability of the DSP ASE
 2012-08-15 10:48 UTC  (2+ messages)

[PATCH] kconfig: remove CONFIG_MTD_NAND_VERIFY_WRITE
 2012-08-15  9:12 UTC  (2+ messages)

[PATCH] MIPS: OCTEON: Fix breakage due to 8250 changes
 2012-08-14 21:46 UTC  (3+ messages)

[PATCH 0/3] MIPS: BCM47xx: use gpiolib
 2012-08-14 12:55 UTC  (6+ messages)
` [PATCH 1/3] ssb: add function to return number of gpio lines
` [PATCH 2/3] bcma: add GPIO driver for SoCs
` [PATCH 3/3] MIPS: BCM47xx: rewrite GPIO handling and use gpiolib

[PATCH V6 4/5] USB: Add EHCI bus glue for Loongson1x SoCs (UPDATED)
 2012-08-14 12:49 UTC  (2+ messages)

[PATCH]: Improve atomic.h robustness
 2012-08-14 12:37 UTC  (2+ messages)

[PATCH v3 0/4] MIPS: ath79: various fixes
 2012-08-14 12:29 UTC  (13+ messages)
` [PATCH v3 1/4] MIPS: ath79: fix number of GPIO lines for AR724[12]
` [PATCH v3 2/4] MIPS: ath79: use correct IRQ number for the OHCI controller on AR7240
` [PATCH v3 3/4] MIPS: ath79: select HAVE_CLK
` [PATCH v3 4/4] MIPS: ath79: don't override CPU ASE features

[PATCH 1/2] MIPS: Netlogic: define cpu_has_fpu macro
 2012-08-14 11:30 UTC  (2+ messages)
` [PATCH 2/2] MIPS: Synchronize MIPS count one CPU at a time

[Bug-fix] backtrace when HAVE_FUNCTION_TRACER is enable
 2012-08-14 11:15 UTC  (7+ messages)

[PATCH v3 13/32] PCI/MIPS: use PCIe capabilities access functions to simplify implementation
 2012-08-13 21:40 UTC  (2+ messages)

[PATCH v2 0/6] Avoid cache trashing on clearing huge/gigantic page
 2012-08-13 19:07 UTC  (18+ messages)
` [PATCH v2 1/6] THP: Use real address for NUMA policy
` [PATCH v2 2/6] mm: make clear_huge_page tolerate non aligned address
` [PATCH v2 3/6] THP: Pass real, not rounded, address to clear_huge_page
` [PATCH v2 4/6] x86: Add clear_page_nocache
` [PATCH v2 5/6] mm: make clear_huge_page cache clear only around the fault address
` [PATCH v2 6/6] x86: switch the 64bit uncached page clear to SSE/AVX v2

[PATCH] MIPS: Fix poweroff failure when HOTPLUG_CPU configured
 2012-08-13  2:06 UTC 

[PATCH 01/16] MIPS: Loongson: Add basic Loongson-3 definition
 2012-08-13  2:05 UTC  (2+ messages)

[PATCH] MIPS: OCTEON: Fix broken interrupt controller code
 2012-08-10 23:00 UTC 

[PATCH v2] MIPS: init module specific mips_hi16_list to NULL
 2012-08-10 14:49 UTC 

Direct I/O bug in kernel
 2012-08-10 12:18 UTC  (5+ messages)

[PATCH] MIPS: init module specific mips_hi16_list to NULL
 2012-08-10 10:38 UTC  (2+ messages)

[PATCH V4 00/16] MIPS: Add Loongson-3 based machines support
 2012-08-09  5:59 UTC  (7+ messages)
` [PATCH V4 12/16] ALSA: HDA: Make hda sound card usable for Loongson
  ` [alsa-devel] "

[Memory leak]: memory leak in apply_r_mips_lo16_rel
 2012-08-08 13:04 UTC  (3+ messages)

[PATCH] usb: host: mips: sead3: Update for EHCI register structure
 2012-08-07 17:21 UTC  (4+ messages)

[PATCH v3 0/3] MIPS: ath79: allow to use USB on AR934x
 2012-08-04 16:03 UTC  (4+ messages)
` [PATCH v3 1/3] MIPS: ath79: use a helper function for USB resource initialization
` [PATCH v3 2/3] MIPS: ath79: add USB platform setup code for AR934X
` [PATCH v3 3/3] MIPS: ath79: register USB host controller on the DB120 board


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox