messages from 2026-10-12 02:29:58 to 2026-10-14 20:44:22 UTC [more...]
[PATCH 0/8] bcma-ac-rev1: support 4352/4360 rev3 chips
2026-10-14 20:41 UTC (9+ messages)
` [PATCH 1/8] bcma: core: clear only FORCEHT for BCMA_CLKMODE_DYNAMIC
` [PATCH 2/8] bcma: pmu: init PLL and resources on BCM4352/BCM4360
` [PATCH 3/8] bcma: pcie2: request HT "
` [PATCH 4/8] bcma: chipcommon: set corecontrol bits 5:2 "
` [PATCH 5/8] bcma: extract SPROM revision 11
` [PATCH 6/8] firmware: bcm47xx_sprom: read ledbh4..ledbh15 from NVRAM
` [PATCH 7/8] firmware: bcm47xx_sprom: read boardflags3 and AvVmid_c0..2 "
` [PATCH 8/8] bcma: add the BCM4352 PCI ID
[PATCH v9 0/5] clocksource/timer-econet-en751221: Support irq number per timer
2026-10-14 20:36 UTC (4+ messages)
` [PATCH v9 5/5] clocksource/timer-econet-en751221: Support EN751627 without percpu IRQ
[PATCH 0/2] lib/crypto: Use size_t lengths for Poly1305 and ChaCha
2026-10-14 20:39 UTC (4+ messages)
` [PATCH 1/2] lib/crypto: poly1305: Use size_t length
` [PATCH 2/2] lib/crypto: chacha: "
[PATCH 0/2] lib/crypto: chacha: Handle lengths of 2 GiB or more on 32-bit arm and MIPS
2026-10-14 20:34 UTC (3+ messages)
` [PATCH 1/2] lib/crypto: arm/chacha: Handle lengths of 2 GiB or more in scalar code
` [PATCH 2/2] lib/crypto: mips/chacha: Handle lengths of 2 GiB or more
[PATCH 0/5] lib/crypto: Handle large lengths in poly1305 and chacha20poly1305
2026-10-14 15:29 UTC (8+ messages)
` [PATCH 1/5] lib/crypto: riscv/poly1305: Fix 32-bit length treated as 64-bit
` [PATCH 2/5] lib/crypto: mips/poly1305: "
` [PATCH 3/5] lib/crypto: arm64/poly1305: "
` [PATCH 4/5] lib/crypto: poly1305: Take a size_t length in poly1305_update()
` [PATCH 5/5] lib/crypto: chacha: Take a size_t length in chacha_crypt()
[PATCH net-next v16 0/7] net: stmmac: qcom-ethqos: add support for SCMI power domains
2026-10-14 12:36 UTC (8+ messages)
` [PATCH net-next v16 1/7] net: stmmac: dwmac4: don't program the 1us tick counter without a CSR clock
` [PATCH net-next v16 2/7] dt-bindings: net: qcom: document the ethqos device for SCMI-based systems
` [PATCH net-next v16 3/7] net: stmmac: qcom-ethqos: set serdes mode before powerup
` [PATCH net-next v16 4/7] net: stmmac: qcom-ethqos: update phy_mode to the resolved interface in mac_finish()
` [PATCH net-next v16 5/7] net: stmmac: qcom-ethqos: reuse the address of ethqos_emac_driver_data
` [PATCH net-next v16 6/7] net: stmmac: qcom-ethqos: factor out linux-level setup into a separate function
` [PATCH net-next v16 7/7] net: stmmac: qcom-ethqos: add support for sa8255p
[PATCH 00/21] mm: change behavior of pXdp_get()/pXd_page() in compile-time folded pgtable
2026-10-14 9:40 UTC (6+ messages)
` [PATCH 11/21] riscv: mm: use proper set_pXd() for generic compile-time folded patable in vmalloc_fault()
[PATCH 0/3] mm: Generalize page table allocation helpers
2026-10-14 3:59 UTC (4+ messages)
` [PATCH 1/3] mm: generalize kernel PTE table allocation
` [PATCH 2/3] mm: generalize PMD page "
` [PATCH 3/3] mm: generalize PUD "
[PATCH v4 0/5] MIPS: GIC clocksource/irqchip improvements and fixes for multi-cluster systems
2026-10-12 14:02 UTC (3+ messages)
[PATCH v2 0/5] bcma: support the BCM6362 integrated WLAN backplane
2026-10-13 17:26 UTC (10+ messages)
` [PATCH v2 1/5] dt-bindings: bus: add Broadcom BCM6362 WLAN AXI backplane
[PATCH v2 00/53] MIPS: SGI-IP27: add support for the IP35 (Bedrock hub) machines
2026-10-13 15:13 UTC (60+ messages)
` [PATCH v2 01/53] MIPS: PCI: xtalk-bridge: refuse device numbers past the last slot
` [PATCH v2 02/53] MIPS: PCI: xtalk-bridge: assign slots the PROM leaves unconfigured
` [PATCH v2 03/53] MIPS: PCI: xtalk-bridge: write a type 1 IOC3 through the type 1 window
` [PATCH v2 04/53] MIPS: PCI: xtalk-bridge: flush config space writes
` [PATCH v2 05/53] MIPS: PCI: xtalk-bridge: reassign slots whose devio window maps elsewhere
` [PATCH v2 06/53] MIPS: Xtalk: guard the widget identification table from assembly
` [PATCH v2 07/53] MIPS: SGI-IP27: dump the NMI save areas the CPU scan recorded
` [PATCH v2 08/53] MIPS: SGI-IP27: add REMOTE_HUB_PI_S()/REMOTE_HUB_PI_L()
` [PATCH v2 09/53] MIPS: SGI-IP27: detect Bedrock hubs at boot
` [PATCH v2 10/53] MIPS: SGI-IP27: widen Kconfig for the Bedrock-based machines
` [PATCH v2 11/53] MIPS: SGI-IP27: fold the dead SN1 arm out of klconfig.h
` [PATCH v2 12/53] MIPS: SGI-IP27: choose the node address layout at runtime
` [PATCH v2 13/53] MIPS: SGI-IP27: add the Bedrock hub register windows
` [PATCH v2 14/53] MIPS: SGI-IP27: decode a Bedrock hub's node id and system size
` [PATCH v2 15/53] MIPS: SGI-IP27: put a Bedrock hub's boot CPU in slot 0
` [PATCH v2 16/53] MIPS: SGI-IP27: lay out node memory in 1GB banks on Bedrock hubs
` [PATCH v2 17/53] MIPS: SGI-IP27: reserve the bottom 64MB of node 0 "
` [PATCH v2 18/53] MIPS: SGI-IP27: route interrupt masks and slices through both PIs
` [PATCH v2 19/53] MIPS: SGI-IP27: address a CPU's own PI for NMI, IPI and RT counter
` [PATCH v2 20/53] MIPS: SGI-IP27: take a CPU's node from the CPU table in per_cpu_init()
` [PATCH v2 21/53] MIPS: SGI-IP27: resolve the mapped-kernel node shift at runtime
` [PATCH v2 22/53] MIPS: SGI-IP27: load the kernel at node offset 0x40000
` [PATCH v2 23/53] MIPS: SGI-IP27: xbow_probe(): recognize KLTYPE_PBRICK_XBOW
` [PATCH v2 24/53] MIPS: ip27_defconfig: enable the IOC3 MFD, its cell drivers and tg3
` [PATCH v2 25/53] net: ethernet: sgi: ioc3-eth: apply the DMA attributes only to 64-bit addresses
` [PATCH v2 26/53] MIPS: SGI-IP27: pick the XBridge and PIC DMA address form by mask
` [PATCH v2 27/53] MIPS: SGI-IP27: recognize the PXBow crossbar
` [PATCH v2 28/53] MIPS: PCI: xtalk-bridge: recognize the PIC widget's 64-bit-only registers
` [PATCH v2 29/53] MIPS: PCI: xtalk-bridge: match PIC's register-level differences
` [PATCH v2 30/53] rtc: m48t35: support the SGI IP35 timekeeper's 1968 year base
` [PATCH v2 31/53] mfd: ioc3: Add support for IOC4
` [PATCH v2 32/53] MIPS: SGI-IP27: dispatch the early console between IOC3 and IOC4
` [PATCH v2 33/53] MIPS: SGI-IP27: add L1 system controller support
` [PATCH v2 34/53] MIPS: SGI-IP27: wire the L1 into reset and the Ethernet address
` [PATCH v2 35/53] MIPS: PCI: xtalk-bridge: take the board part number from the L1
` [PATCH v2 36/53] mfd: ioc3: Add IP34 system-board entry to ioc3_infos[]
` [PATCH v2 37/53] mfd: ioc3: Cross the serial IRQs on the Origin 300 IO8
` [PATCH v2 38/53] net: ethernet: sgi: ioc3-eth: fall back to the platform MAC address
` [PATCH v2 39/53] MIPS: SGI-IP27: don't register a w1 master on an XBridge or PIC
` [PATCH v2 40/53] MIPS: SGI-IP27: report a Bedrock machine as SGI IP35
` [PATCH v2 41/53] MIPS: SGI-IP27: identify the machine by the L1 brick type
` [PATCH v2 42/53] MIPS: SGI-IP27: register the Odyssey graphics widget
` [PATCH v2 43/53] MIPS: SGI-IP27: take the console from the KLCONFIG header on IP35
` [PATCH v2 44/53] MIPS: SGI-IP27: give each CPU its own topology package id
` [PATCH v2 45/53] ata: add pata_sgiioc4 driver for the SGI IOC4 ATA/ATAPI controller
` [PATCH v2 46/53] mfd: ioc3: Add IOC4 ATA/ATAPI cell
` [PATCH v2 47/53] MAINTAINERS: add an entry for the SGI IOC4 ATA driver
` [PATCH v2 48/53] MIPS: ip27_defconfig: update for the onboard hardware
` [PATCH v2 49/53] MIPS: ip27_defconfig: enable pata_sgiioc4 and the DVD-ROM path
` [PATCH v2 50/53] MIPS: SGI-IP27: add L1 front-panel LED and display requests
` [PATCH v2 51/53] leds: Add driver for the SGI Fuel and Tezro front-panel LEDs
` [PATCH v2 52/53] MIPS: SGI-IP27: show the OS state on the Fuel and Tezro front panels
` [PATCH v2 53/53] MIPS: ip27_defconfig: enable the Fuel and Tezro front-panel LEDs
[PATCH v3 3/8] PCI: Honor alignment overrides
2026-10-13 14:08 UTC (2+ messages)
[PATCH v1 0/7] gpiolib: kill gpio_request_one()
2026-10-13 13:55 UTC (5+ messages)
[PATCH v2 6/6] serial: 8250: make port operations work on struct uart_8250_port
2026-10-13 13:42 UTC (11+ messages)
[PATCH v3 00/14] audit: log all six syscall arguments in the SYSCALL record
2026-10-13 12:35 UTC (3+ messages)
[PATCH 0/2] MIPS: SGI-IP30: power off through the RTC
2026-10-13 11:58 UTC (3+ messages)
` [PATCH 1/2] MIPS: SGI-IP30: power off through the DS1687 RTC
` [PATCH 2/2] MIPS: SGI-IP30: shut down cleanly on a power button press
[RFC PATCH v3 00/13] lib, sched: Introduce sparsebitmap (sbm)
2026-10-13 10:14 UTC (12+ messages)
` [RFC PATCH v3 01/13] lib/sbm: Introduce helpers for architectures to configure LLC properties
` [RFC PATCH v3 02/13] drivers/base/arch_topology: Add support for initializing sbm topology
` [RFC PATCH v3 06/13] powerpc/setup: Initialize sbm topology based on coregroup / NUMA topology
` [RFC PATCH v3 07/13] s390/topology: Initialize sbm topology during topology_init_early()
[PATCH 0/3] MIPS: SGI fixes
2026-10-13 9:45 UTC (4+ messages)
` [PATCH 1/3] MIPS: sgi-ip32: Clear latched CRIME errors at boot
` [PATCH 2/3] MIPS: sgi-ip32: Reserve the firmware memory
` [PATCH 3/3] MIPS: SGI-IP30: fix the defconfig defaults for the Bridge PROM and RTC
[PATCH] MIPS: lib: prefetch ahead in csum_partial()
2026-10-13 4:28 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox