Re: [PATCH v5 0/7] Add EcoNet EN751221 MIPS platform support

[Daniel Lezcano <daniel.lezcano@linaro.org>]

On Wed, May 07, 2025 at 01:44:53PM +0000, Caleb James DeLisle wrote:
> EcoNet MIPS SoCs are big endian machines based on 34Kc and 1004Kc
> processors. They are found in xDSL and xPON modems, and contain PCM
> (VoIP), Ethernet, USB, GPIO, I2C, SPI (Flash), UART, and PCIe.
> 
> The EcoNet MIPS SoCs are divided broadly into two families, the
> EN751221 family based on the 34Kc, and the EN751627 family based on
> the 1004Kc. Individual SoCs within a family are very similar, only
> with different peripherals.
> 
> This patchset adds basic "boots to a console" support for the EN751221
> family and adds SmartFiber XP8421-B, a low cost commercially available
> board that is useful for testing and development.
> 
> Note that Airoha (AN7523, AN7581) is similar to EcoNet in terms of
> peripherals, and for historical reasons Airoha chips are sometimes
> referred to with the EN75xx prefix. However this is a different
> platform because Airoha chips are ARM based.
> 
> This patchset is against mips-next.
> 
> v4 -> v5
> * 2/7 clocksource/drivers: Add EcoNet Timer HPT driver:
>   * Improve explanation of HPT timer in changelog
>   * Move pr_info to pr_debug per recommendation
>   * Remove pointless debug on spurious interrupt
>   * Small code-style change

Shall I pick the clocksource + bindings changes through my tree ?

-- 

 <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog