Re: [PATCH R3 7/7] xen/balloon: Memory hotplug support for Xen balloon driver

[Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>]

On Tue, Feb 08, 2011 at 09:22:26AM -0800, Dave Hansen wrote:
> On Mon, 2011-02-07 at 15:12 +0100, Daniel Kiper wrote:
> > On Thu, Feb 03, 2011 at 10:12:24AM -0800, Dave Hansen wrote:
> > > On Thu, 2011-02-03 at 17:30 +0100, Daniel Kiper wrote:
> > > > +static struct resource *allocate_memory_resource(unsigned long nr_pages)
> > > > +{
> > > > +	resource_size_t r_min, r_size;
> > > > +	struct resource *r;
> > > > +
> > > > +	/*
> > > > +	 * Look for first unused memory region starting at page
> > > > +	 * boundary. Skip last memory section created at boot time
> > > > +	 * because it may contains unused memory pages with PG_reserved
> > > > +	 * bit not set (online_pages() require PG_reserved bit set).
> > > > +	 */
> > >
> > > Could you elaborate on this comment a bit?  I think it's covering both
> > > the "PAGE_SIZE" argument to allocate_resource() and something else, but
> > > I'm not quite sure.
> > 
> > Yes, you are right. Aligment to PAGE_SIZE is done by allocate_resource().
> > Additionally, r_min (calculated below) sets lower limit at which hoplugged
> > memory could be installed (due to PG_reserved bit requirment set up by
> > online_pages()). Later r_min is put as an argument to allocate_resource() call.
> 
> OK, and you'll update the comment on that?
> 
> > > > +	r = kzalloc(sizeof(struct resource), GFP_KERNEL);
> > > > +
> > > > +	if (!r)
> > > > +		return NULL;
> > > > +
> > > > +	r->name = "System RAM";
> > > > +	r->flags = IORESOURCE_MEM | IORESOURCE_BUSY;
> > > > +	r_min = PFN_PHYS(section_nr_to_pfn(pfn_to_section_nr(balloon_stats.boot_max_pfn) + 1));
> > >
> > > Did you do this for alignment reasons?  It might be a better idea to
> > > just make a nice sparsemem function to do alignment.
> > 
> > Please look above.
> 
> You spoke about page alignment up there.  Why is this section-aligned?
> Should we make an "align to section" function in generic sparsemem code?
> 
> > > > +	r_size = nr_pages << PAGE_SHIFT;
> > > > +
> > > > +	if (allocate_resource(&iomem_resource, r, r_size, r_min,
> > > > +					ULONG_MAX, PAGE_SIZE, NULL, NULL) < 0) {
> > > > +		kfree(r);
> > > > +		return NULL;
> > > > +	}
> > > > +
> > > > +	return r;
> > > > +}
> > >
> > > This function should probably be made generic.  I bet some more
> > > hypervisors come around and want to use this.  They generally won't care
> > > where the memory goes, and the kernel can allocate a spot for them.
> > 
> > Yes, you are right. I think about new project in which
> > this function will be generic and then I would move it to
> > some more generic place. Now, I think it should stay here.
> 
> Please move it to generic code.  It doesn't belong in Xen code.  
> 
> > > In other words, I think you can take everything from and including
> > > online_pages() down in the function and take it out.  Use a udev hotplug
> > > rule to online it immediately if that's what you want.
> > 
> > I agree. I discussed a bit about this problem with Jeremy, too. However,
> > there are some problems to implement that solution now. First of all it is
> > possible to online hotplugged memory using sysfs interface only in chunks
> > called sections. It means that it is not possible online once again section
> > which was onlined ealier partialy populated and now it contains new pages
> > to online. In this situation sysfs interface emits Invalid argument error.
> > In theory it should be possible to offline and then online whole section
> > once again, however, if memory from this section was used is not possible
> > to do that. It means that those properties does not allow hotplug memory
> > in guest in finer granulity than section and sysfs interface is too inflexible
> > to be used in that solution. That is why I decided to online hoplugged memory
> > using API which does not have those limitations.
> 
> Sure, you have to _online_ the whole thing at once, but you don't have
> to actually make the pages available.  You also don't need to hook in to
> the memory resource code like you're doing.  It's sufficient to just try
> and add the memory.  If you get -EEXIST, then you can't add it there, so
> move up and try again.  
> 
> int xen_balloon_add_memory(u64 size)
> {
> 	unsigned long top_of_mem = max_pfn;
> 	top_of_mem = section_align_up(top_of_mem);
> 
> 	while (1) {
> 		int ret = add_memory(nid, top_of_mem, size);
> 		if (ret == -EEXIST)
> 			continue;
> 		// error handling...
> 		break;
> 	}
> 	return...;
> }
> 
> As for telling the hypervisor where you've mapped things, that should be
> done in arch_add_memory().  
> 
> When it comes down to online_page(), you don't want your pages freed
> back in to the buddy allocator, you want them put in to the balloon.
> So, take the __free_page() in online_page(), and put a Xen hook in
> there.  
> 
> +void __attribute__((weak)) arch_free_hotplug_page(struct page *page)
> +{
> +	__free_page(page);
> +}

I somehow have a vague recollection that the __weak was frowned upon? The issues
were that when you compile a pv-ops kernel it can run as baremetal so the..

> 
> void online_page(struct page *page)
> {
>         unsigned long pfn = page_to_pfn(page);
> ...
> -       __free_page(page);
> +	arch_free_hotplug_page(page);
> }
> 
> Then, have Xen override it:
> 
> void arch_free_hotplug_page(struct page *page)
> {
> 	if (xen_need_to_inflate_balloon())
> 		put_page_in_balloon(page);	
> 	else
> 		__free_page(page);

 call above would get called even on baremetal (and would require the header
file arch/x86/include/memory_hotplug.h to pull in header file from the balloon
driver). If we are going to persue this it might be prudent to follow what we did for MSI:


1525bf0d8f059a38c6e79353583854e1981b2e67
294ee6f89cfd629e276f632a6003a0fad7785dce
b5401a96b59475c1c878439caecb8c521bdfd4ad

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>