From: Mel Gorman <mgorman@suse.de>
To: Andrew Morton <akpm@linux-foundation.org>
Cc: Linux-MM <linux-mm@kvack.org>, Nathan Zimmer <nzimmer@sgi.com>,
Dave Hansen <dave.hansen@intel.com>,
Waiman Long <waiman.long@hp.com>,
Scott Norton <scott.norton@hp.com>,
Daniel J Blueman <daniel@numascale.com>,
LKML <linux-kernel@vger.kernel.org>
Subject: Re: [PATCH 07/13] mm: meminit: Initialise a subset of struct pages if CONFIG_DEFERRED_STRUCT_PAGE_INIT is set
Date: Tue, 28 Apr 2015 15:56:32 +0100 [thread overview]
Message-ID: <20150428145632.GN2449@suse.de> (raw)
In-Reply-To: <20150428064810.0882ad36.akpm@linux-foundation.org>
On Tue, Apr 28, 2015 at 06:48:10AM -0700, Andrew Morton wrote:
> On Tue, 28 Apr 2015 10:53:23 +0100 Mel Gorman <mgorman@suse.de> wrote:
>
> > > > +#ifdef CONFIG_DEFERRED_STRUCT_PAGE_INIT
> > > > +#define __defermem_init __meminit
> > > > +#define __defer_init __meminit
> > > > +#else
> > > > +#define __defermem_init
> > > > +#define __defer_init __init
> > > > +#endif
> > >
> > > Could we get some comments describing these? What they do, when and
> > > where they should be used. I have a suspicion that the naming isn't
> > > good, but I didn't spend a lot of time reverse-engineering the
> > > intent...
> > >
> >
> > Of course. The next version will have
> >
> > +/*
> > + * Deferred struct page initialisation requires some early init functions that
> > + * are removed before kswapd is up and running. The feature depends on memory
> > + * hotplug so put the data and code required by deferred initialisation into
> > + * the __meminit section where they are preserved.
> > + */
>
> I'm still not getting it even a little bit :( You say "data and code",
> so I'd expect to see
>
> #define __defer_meminitdata __meminitdata
> #define __defer_meminit __meminit
>
> But the patch doesn't mention the data segment at all.
>
Take 2. Suggestions on different names are welcome because they are poor.
/*
* Deferred struct page initialisation requires init functions that are freed
* before kswapd is available. Reuse the memory hotplug section annotation
* to mark the required code.
*
* __defermem_init is code that always exists but is annotated __meminit to
* avoid section warnings.
* __defer_init code gets marked __meminit when deferring struct page
* initialistion but is otherwise in the init section.
*/
--
Mel Gorman
SUSE Labs
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>
next prev parent reply other threads:[~2015-04-28 14:56 UTC|newest]
Thread overview: 37+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-04-23 10:33 [PATCH 0/13] Parallel struct page initialisation v3 Mel Gorman
2015-04-23 10:33 ` [PATCH 01/13] memblock: Introduce a for_each_reserved_mem_region iterator Mel Gorman
2015-04-23 10:33 ` [PATCH 02/13] mm: meminit: Move page initialization into a separate function Mel Gorman
2015-04-27 22:46 ` Andrew Morton
2015-04-28 8:28 ` Mel Gorman
2015-04-28 16:02 ` nzimmer
2015-04-28 22:41 ` Andrew Morton
2015-04-28 23:05 ` Mel Gorman
2015-04-23 10:33 ` [PATCH 03/13] mm: meminit: Only set page reserved in the memblock region Mel Gorman
2015-04-27 22:43 ` Andrew Morton
2015-04-23 10:33 ` [PATCH 04/13] mm: page_alloc: Pass PFN to __free_pages_bootmem Mel Gorman
2015-04-23 10:33 ` [PATCH 05/13] mm: meminit: Make __early_pfn_to_nid SMP-safe and introduce meminit_pfn_in_nid Mel Gorman
2015-04-27 22:43 ` Andrew Morton
2015-04-28 9:37 ` Mel Gorman
2015-04-23 10:33 ` [PATCH 06/13] mm: meminit: Inline some helper functions Mel Gorman
2015-04-23 10:33 ` [PATCH 07/13] mm: meminit: Initialise a subset of struct pages if CONFIG_DEFERRED_STRUCT_PAGE_INIT is set Mel Gorman
2015-04-23 15:56 ` Mel Gorman
2015-04-27 22:43 ` Andrew Morton
2015-04-28 9:53 ` Mel Gorman
2015-04-28 13:48 ` Andrew Morton
2015-04-28 14:56 ` Mel Gorman [this message]
2015-04-23 10:33 ` [PATCH 08/13] mm: meminit: Initialise remaining struct pages in parallel with kswapd Mel Gorman
2015-04-27 22:43 ` Andrew Morton
2015-04-23 10:33 ` [PATCH 09/13] mm: meminit: Minimise number of pfn->page lookups during initialisation Mel Gorman
2015-04-23 10:33 ` [PATCH 10/13] x86: mm: Enable deferred struct page initialisation on x86-64 Mel Gorman
2015-04-23 10:33 ` [PATCH 11/13] mm: meminit: Free pages in large chunks where possible Mel Gorman
2015-04-27 22:43 ` Andrew Morton
2015-04-28 11:38 ` Mel Gorman
2015-04-23 10:33 ` [PATCH 12/13] mm: meminit: Reduce number of times pageblocks are set during struct page init Mel Gorman
2015-04-23 10:33 ` [PATCH 13/13] mm: meminit: Remove mminit_verify_page_links Mel Gorman
2015-04-23 15:53 ` [PATCH 0/13] Parallel struct page initialisation v3 Daniel J Blueman
2015-04-23 16:30 ` Mel Gorman
2015-04-24 19:48 ` Waiman Long
2015-04-29 1:31 ` Waiman Long
-- strict thread matches above, loose matches on Subject: below --
2015-04-28 14:36 [PATCH 0/13] Parallel struct page initialisation v4 Mel Gorman
2015-04-28 14:37 ` [PATCH 07/13] mm: meminit: Initialise a subset of struct pages if CONFIG_DEFERRED_STRUCT_PAGE_INIT is set Mel Gorman
2015-04-29 21:19 ` Andrew Morton
2015-04-30 8:45 ` Mel Gorman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150428145632.GN2449@suse.de \
--to=mgorman@suse.de \
--cc=akpm@linux-foundation.org \
--cc=daniel@numascale.com \
--cc=dave.hansen@intel.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=nzimmer@sgi.com \
--cc=scott.norton@hp.com \
--cc=waiman.long@hp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).