Re: Possible broken MM code in dell-laptop.c?

["Pali Rohár" <pali.rohar@gmail.com>]

[-- Attachment #1: Type: Text/Plain, Size: 1436 bytes --]

On Monday 15 June 2015 22:36:45 Darren Hart wrote:
> On Sun, Jun 14, 2015 at 11:05:07AM +0200, Pali Rohár wrote:
> > Hello,
> > 
> > in drivers/platform/x86/dell-laptop.c is this part of code:
> > 
> > static int __init dell_init(void)
> > {
> > ...
> > 
> > 	/*
> > 	
> > 	 * Allocate buffer below 4GB for SMI data--only 32-bit physical
> > 	 addr * is passed to SMI handler.
> > 	 */
> > 	
> > 	bufferpage = alloc_page(GFP_KERNEL | GFP_DMA32);
> > 	if (!bufferpage) {
> > 	
> > 		ret = -ENOMEM;
> > 		goto fail_buffer;
> > 	
> > 	}
> > 	buffer = page_address(bufferpage);
> > 	
> > 	ret = dell_setup_rfkill();
> > 	
> > 	if (ret) {
> > 	
> > 		pr_warn("Unable to setup rfkill\n");
> > 		goto fail_rfkill;
> > 	
> > 	}
> > 
> > ...
> > 
> > fail_rfkill:
> > 	free_page((unsigned long)bufferpage);
> > 
> > fail_buffer:
> > ...
> > }
> > 
> > Then there is another part:
> > 
> > static void __exit dell_exit(void)
> > {
> > ...
> > 
> > 	free_page((unsigned long)buffer);
> 
> I believe you are correct, and this should be bufferpage. Have you
> observed any failures?

Rmmoding dell-laptop.ko works fine. There is no error in dmesg. I think 
that buffer (and not bufferpage) should be passed to free_page(). So in 
my opinion problem is at fail_rfkill: label and not in dell_exit().

But somebody from linux-mm should look at it...

-- 
Pali Rohár
pali.rohar@gmail.com

[-- Attachment #2: This is a digitally signed message part. --]
[-- Type: application/pgp-signature, Size: 198 bytes --]