[PATCH v3 1/8] mm/dax: Dump start address in fault handler

[Peter Xu <peterx@redhat.com>]

Currently the dax fault handler dumps the vma range when dynamic debugging
enabled.  That's mostly not useful.  Dump the (aligned) address instead
with the order info.

Signed-off-by: Peter Xu <peterx@redhat.com>
---
 drivers/dax/device.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/dax/device.c b/drivers/dax/device.c
index eb61598247a9..714174844ca5 100644
--- a/drivers/dax/device.c
+++ b/drivers/dax/device.c
@@ -235,9 +235,9 @@ static vm_fault_t dev_dax_huge_fault(struct vm_fault *vmf, unsigned int order)
 	int id;
 	struct dev_dax *dev_dax = filp->private_data;
 
-	dev_dbg(&dev_dax->dev, "%s: %s (%#lx - %#lx) order:%d\n", current->comm,
-			(vmf->flags & FAULT_FLAG_WRITE) ? "write" : "read",
-			vmf->vma->vm_start, vmf->vma->vm_end, order);
+	dev_dbg(&dev_dax->dev, "%s: op=%s addr=%#lx order=%d\n", current->comm,
+		(vmf->flags & FAULT_FLAG_WRITE) ? "write" : "read",
+		vmf->address & ~((1UL << (order + PAGE_SHIFT)) - 1), order);
 
 	id = dax_read_lock();
 	if (order == 0)
-- 
2.45.0