Re: vchiq: Performance regression since 5.18-rc1

[Phil Elwell <phil@raspberrypi.com>]

Hi Stefan,

On 23/05/2022 07:19, Stefan Wahren wrote:
> Hi Paul,
> 
> Am 23.05.22 um 06:48 schrieb Paul E. McKenney:
>> On Sun, May 22, 2022 at 05:11:36PM +0200, Stefan Wahren wrote:
>>> Hi Paul,
>>>
>>> Am 22.05.22 um 01:46 schrieb Paul E. McKenney:
>>>> On Sun, May 22, 2022 at 01:22:00AM +0200, Stefan Wahren wrote:
>>>>> Hi,
>>>>>
>>>>> while testing the staging/vc04_services/interface/vchiq_arm driver with my
>>>>> Raspberry Pi 3 B+ (multi_v7_defconfig) i noticed a huge performance
>>>>> regression since [ff042f4a9b050895a42cae893cc01fa2ca81b95c] mm:
>>>>> lru_cache_disable: replace work queue synchronization with synchronize_rcu
>>>>>
>>>>> Usually i run "vchiq_test -f 1" to see the driver is still working [1].
>>>>>
>>>>> Before commit:
>>>>>
>>>>> real    0m1,500s
>>>>> user    0m0,068s
>>>>> sys    0m0,846s
>>>>>
>>>>> After commit:
>>>>>
>>>>> real    7m11,449s
>>>>> user    0m2,049s
>>>>> sys    0m0,023s
>>>>>
>>>>> Best regards
>>>>>
>>>>> [1] - https://github.com/raspberrypi/userland
>>>> Please feel free to try the patch shown below.  Or the pair of patches
>>>> from Rik here:
>>>>
>>>> https://lore.kernel.org/lkml/20220218183114.2867528-2-riel@surriel.com/
>>>> https://lore.kernel.org/lkml/20220218183114.2867528-3-riel@surriel.com/
>>> I tried your patch and Rik's patches but in both cases vchiq_test runs 7
>>> minutes instead of ~ 1 second.
>> That is surprising.  Do you boot with rcupdate.rcu_normal=1?
> No, not explicit.
>>    That would
>> nullify my patch, but I would expect that Rik's patch would still provide
>> increased performance even in that case.
> I will retest with a fresh SD card image.
>>
>> Could you please characterize where the slowdown is occurring?
> 
> Unfortunately i don't have a deep insight into driver and vchiq_test tool. Just 
> a user view.
> 
> Do you think an strace would be a good starting point?
> 
> @Phil Any advices to analyse this issue?

Sending many small control packets:

    vchiq_test -c 1 10000

essentially tests interrupt latency. Using a small number of large bulk transfers:

    vchiq_test -b 10000 1

becomes a test of how long it takes to lock down pages. It also tests DMA 
transfer speeds, but since the DMA is run by the firmware (which you aren't 
changing), I think you can rule that.

You may also find it helpful to include "force_turbo=1" in config.txt for more 
predictable results.

By the way, running our 5.18-rc7-based branch on a 3B+ I'm not seeing any 
performance problems:

pi@raspberrypi:~$ time vchiq_test -f 1
Functional test - iters:1
======== iteration 1 ========
Testing bulk transfer for alignment.
Testing bulk transfer at PAGE_SIZE.

real    0m0.512s
user    0m0.042s
sys     0m0.165s

Phil