Re: Problem with 2.6.20 and highmem64

Re: Problem with 2.6.20 and highmem64

[Nilshar]

Adding linux-mm@kvack.org

2007/2/16, Nilshar <nilshar@gmail.com>:
> I can confirm that it works fine with 2.6.20-rc2.
> Do you need me to try any other ? do you need any more info ?
>
> 2007/2/14, Nilshar <nilshar@gmail.com>:
> > Hello,
> > I have an issue with latest 2.6.20 kernel..
> > my last kernel was a 2.6.18 and I wanted to upgrade to a 2.6.20, I
> > copied .config and did a make menuconfig, then save/quit. I compiled
> > new kernel, all went fine.
> > I installed it and at boot time, I had a hang just after "Freeing
> > unused kernel memory" where INIT is supposed to start.
> > After searching the web, I found that it is usually the case when
> > wrong process type is configured.. I verified that, but all was fine
> > there.
> > After 10ish compiled kernel, I found that it is when I select highmem64.
> >
> > Diff between working and non working kernel :
> >
> > 181,182c181,182
> > < # CONFIG_HIGHMEM4G is not set
> > < CONFIG_HIGHMEM64G=y
> > ---
> > > CONFIG_HIGHMEM4G=y
> > > # CONFIG_HIGHMEM64G is not set
> > 185d184
> > < CONFIG_X86_PAE=y
> > 191c190
> > < CONFIG_RESOURCES_64BIT=y
> > ---
> > > # CONFIG_RESOURCES_64BIT is not set
> >
> > (I just witching highmem 4G and highmem64g).
> >
> > I'll attach the full .config.
> >
> > it used to work fine with highmem64g with a kernel 2.6.18 and 2.6.19
> > (I'm sure it was ok with .20-rc2 but I'll double check that).
> >
> > Is this a bug ? or something I did wrong ?
> >
> > Oh, I probably should add that this hang doesn't occur on all
> > hardware, but it happen on Dell PE 850 at least.
> >
> > If you need additional informations, just ask :)
> >
> >
>

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>

Re: Problem with 2.6.20 and highmem64

[Leroy van Logchem]

> Adding linux-mm <at> kvack.org

> > > I installed it and at boot time, I had a hang just after "Freeing
> > > unused kernel memory" where INIT is supposed to start.

Me too.

> > > (I just witching highmem 4G and highmem64g).

Same here. Using Supermicro 7044 4GB ram 2.6.20.1 (32bit) kernel.
Compiled using CentOS 4.4's config with make oldconfig.

--
Leroy


--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>