RE: [PATCH 2/3] mmc: correct some exclusive card state to clear

[Seungwon Jeon <tgih.jun@samsung.com>]

On Tue, November 05, 2013, Ulf Hansson wrote:
> Hi Seungwon,
> 
> 
> On 5 November 2013 14:27, Seungwon Jeon <tgih.jun@samsung.com> wrote:
> > Card state related to speed mode should be in non-overlapped.
> > Consideration for all cases is required when being cleared.
> > Also, MMC_STATE_PRESENT and MMC_STATE_REMOVED are same.
> > It's exclusive state which cannot be set at the same time.
> >
> > Signed-off-by: Seungwon Jeon <tgih.jun@samsung.com>
> > ---
> >  drivers/mmc/core/core.c  |    1 -
> >  drivers/mmc/core/mmc.c   |    4 ++--
> >  drivers/mmc/core/sd.c    |    5 +++--
> >  drivers/mmc/core/sdio.c  |    5 ++++-
> >  include/linux/mmc/card.h |   37 +++++++++++++++++++++++++++++++------
> >  5 files changed, 40 insertions(+), 12 deletions(-)
> >
> > diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
> > index 57a2b40..b183d56 100644
> > --- a/drivers/mmc/core/core.c
> > +++ b/drivers/mmc/core/core.c
> > @@ -2281,7 +2281,6 @@ static int mmc_do_hw_reset(struct mmc_host *host, int check)
> >                 }
> >         }
> >
> > -       host->card->state &= ~(MMC_STATE_HIGHSPEED | MMC_STATE_HIGHSPEED_DDR);
> >         if (mmc_host_is_spi(host)) {
> >                 host->ios.chip_select = MMC_CS_HIGH;
> >                 host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
> > diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
> > index f4f8991..1668ea4 100644
> > --- a/drivers/mmc/core/mmc.c
> > +++ b/drivers/mmc/core/mmc.c
> > @@ -1597,11 +1597,11 @@ static int _mmc_suspend(struct mmc_host *host, bool is_suspend)
> >                 err = mmc_sleep(host);
> >         else if (!mmc_host_is_spi(host))
> >                 err = mmc_deselect_cards(host);
> > -       host->card->state &= ~(MMC_STATE_HIGHSPEED | MMC_STATE_HIGHSPEED_200);
> >
> >         if (!err) {
> >                 mmc_power_off(host);
> >                 mmc_card_set_suspended(host->card);
> > +               mmc_card_set_ds(host->card);
> >         }
> >  out:
> >         mmc_release_host(host);
> > @@ -1727,8 +1727,8 @@ static int mmc_power_restore(struct mmc_host *host)
> >  {
> >         int ret;
> >
> > -       host->card->state &= ~(MMC_STATE_HIGHSPEED | MMC_STATE_HIGHSPEED_200);
> >         mmc_claim_host(host);
> > +       mmc_card_set_ds(host->card);
> >         ret = mmc_init_card(host, host->card->ocr, host->card);
> >         mmc_release_host(host);
> >
> > diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c
> > index 6f42050..b19a8f4 100644
> > --- a/drivers/mmc/core/sd.c
> > +++ b/drivers/mmc/core/sd.c
> > @@ -1082,10 +1082,11 @@ static int _mmc_sd_suspend(struct mmc_host *host)
> >
> >         if (!mmc_host_is_spi(host))
> >                 err = mmc_deselect_cards(host);
> > -       host->card->state &= ~MMC_STATE_HIGHSPEED;
> > +
> >         if (!err) {
> >                 mmc_power_off(host);
> >                 mmc_card_set_suspended(host->card);
> > +               mmc_card_set_ds(host->card);
> >         }
> >
> >  out:
> > @@ -1191,8 +1192,8 @@ static int mmc_sd_power_restore(struct mmc_host *host)
> >  {
> >         int ret;
> >
> > -       host->card->state &= ~MMC_STATE_HIGHSPEED;
> >         mmc_claim_host(host);
> > +       mmc_card_set_ds(host->card);
> >         ret = mmc_sd_init_card(host, host->card->ocr, host->card);
> >         mmc_release_host(host);
> >
> > diff --git a/drivers/mmc/core/sdio.c b/drivers/mmc/core/sdio.c
> > index 4d721c6..7c6c43c 100644
> > --- a/drivers/mmc/core/sdio.c
> > +++ b/drivers/mmc/core/sdio.c
> > @@ -968,8 +968,10 @@ static int mmc_sdio_suspend(struct mmc_host *host)
> >                 mmc_release_host(host);
> >         }
> >
> > -       if (!err && !mmc_card_keep_power(host))
> > +       if (!err && !mmc_card_keep_power(host)) {
> >                 mmc_power_off(host);
> > +               mmc_card_set_ds(host->card);
> > +       }
> >
> >         return err;
> >  }
> > @@ -1075,6 +1077,7 @@ static int mmc_sdio_power_restore(struct mmc_host *host)
> >         if (ret)
> >                 goto out;
> >
> > +       mmc_card_set_ds(host->card);
> >         ret = mmc_sdio_init_card(host, host->card->ocr, host->card,
> >                                 mmc_card_keep_power(host));
> >         if (!ret && host->sdio_irqs)
> > diff --git a/include/linux/mmc/card.h b/include/linux/mmc/card.h
> > index c119735..f2c2620 100644
> > --- a/include/linux/mmc/card.h
> > +++ b/include/linux/mmc/card.h
> > @@ -260,6 +260,11 @@ struct mmc_card {
> >  #define MMC_STATE_HIGHSPEED_200        (1<<8)          /* card is in HS200 mode */
> >  #define MMC_STATE_DOING_BKOPS  (1<<10)         /* card is doing BKOPS */
> >  #define MMC_STATE_SUSPENDED    (1<<11)         /* card is suspended */
> > +#define MMC_STATE_SPEED_MASK   (MMC_STATE_HIGHSPEED | \
> > +                                MMC_STATE_HIGHSPEED_DDR | \
> > +                                MMC_STATE_ULTRAHIGHSPEED | \
> > +                                MMC_STATE_HIGHSPEED_200)
> > +                                               /* Mask for default speed(DS) */
> >         unsigned int            quirks;         /* card quirks */
> >  #define MMC_QUIRK_LENIENT_FN0  (1<<0)          /* allow SDIO FN0 writes outside of the VS CCCR range
> */
> >  #define MMC_QUIRK_BLKSZ_FOR_BYTE_MODE (1<<1)   /* use func->cur_blksize */
> > @@ -431,19 +436,39 @@ static inline void __maybe_unused remove_quirk(struct mmc_card *card, int data)
> >  #define mmc_card_doing_bkops(c)        ((c)->state & MMC_STATE_DOING_BKOPS)
> >  #define mmc_card_suspended(c)  ((c)->state & MMC_STATE_SUSPENDED)
> >
> > -#define mmc_card_set_present(c)        ((c)->state |= MMC_STATE_PRESENT)
> > +
> >  #define mmc_card_set_readonly(c) ((c)->state |= MMC_STATE_READONLY)
> > -#define mmc_card_set_highspeed(c) ((c)->state |= MMC_STATE_HIGHSPEED)
> > -#define mmc_card_set_hs200(c)  ((c)->state |= MMC_STATE_HIGHSPEED_200)
> >  #define mmc_card_set_blockaddr(c) ((c)->state |= MMC_STATE_BLOCKADDR)
> > -#define mmc_card_set_ddr_mode(c) ((c)->state |= MMC_STATE_HIGHSPEED_DDR)
> > -#define mmc_card_set_uhs(c) ((c)->state |= MMC_STATE_ULTRAHIGHSPEED)
> >  #define mmc_card_set_ext_capacity(c) ((c)->state |= MMC_CARD_SDXC)
> > -#define mmc_card_set_removed(c) ((c)->state |= MMC_CARD_REMOVED)
> >  #define mmc_card_set_doing_bkops(c)    ((c)->state |= MMC_STATE_DOING_BKOPS)
> >  #define mmc_card_clr_doing_bkops(c)    ((c)->state &= ~MMC_STATE_DOING_BKOPS)
> >  #define mmc_card_set_suspended(c) ((c)->state |= MMC_STATE_SUSPENDED)
> >  #define mmc_card_clr_suspended(c) ((c)->state &= ~MMC_STATE_SUSPENDED)
> > +#define mmc_card_set_highspeed(c) \
> > +                       ((c)->state = \
> > +                        ((c)->state & ~MMC_STATE_SPEED_MASK) | \
> > +                        MMC_STATE_HIGHSPEED)
> > +#define mmc_card_set_ddr_mode(c) \
> > +                       ((c)->state = \
> > +                        ((c)->state & ~MMC_STATE_SPEED_MASK) | \
> > +                        MMC_STATE_HIGHSPEED_DDR)
> > +#define mmc_card_set_hs200(c) \
> > +                       ((c)->state = \
> > +                        ((c)->state & ~MMC_STATE_SPEED_MASK) | \
> > +                        MMC_STATE_HIGHSPEED_200)
> > +#define mmc_card_set_uhs(c) \
> > +                       ((c)->state = \
> > +                        ((c)->state & ~MMC_STATE_SPEED_MASK) | \
> > +                        MMC_STATE_ULTRAHIGHSPEED)
> > +#define mmc_card_set_present(c) \
> > +                       ((c)->state = \
> > +                        ((c)->state & ~MMC_CARD_REMOVED) | \
> > +                        MMC_STATE_PRESENT)
> > +#define mmc_card_set_removed(c) \
> > +                       ((c)->state = \
> > +                        ((c)->state & ~MMC_STATE_PRESENT) | \
> > +                        MMC_CARD_REMOVED)
> > +#define mmc_card_set_ds(c)     ((c)->state &= ~MMC_STATE_SPEED_MASK)
> 
> I have a feeling of that this "card->state" has become a container for
> a lot of mixed stuff. So your clean up is definitely justified.
> 
> I have a suggestion for how we can improve simplicity, how about
> dividing the state into two variables instead:
> 
> -> One part are actually used in the mmc core code to track a state
> and to make certain decisions during execution, like
> MMC_STATE_SUSPENDED, MMC_STATE_PRESENT, MMC_CARD_REMOVED.
> 
> -> The other part is more to be considered as the current operational
> state, for example the bus speed mode. The information in this "state
> variable" will be re-negotiated as a part of mmc_sd|sdio_init_card and
> can therefore always be reset in the beginning of these functions.
> 
> Does it make sense?
Thank you for suggestion. I also feel that.
Hmm, but when considering there is no case we access 'card->sate' directly,
splitting into two types of state doesn't seem to give much.
So I guess being kept is not bad.

Thanks,
Seungwon Jeon

> 
> Kind regards
> Ulf Hansson
> 
> >
> >  /*
> >   * Quirk add/remove for MMC products.
> > --
> > 1.7.0.4
> >
> >
> --
> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html