[PATCH 2/2] brcmfmac: Prevent re-tuning conflicting with 'wake-up'

[Adrian Hunter <adrian.hunter@intel.com>]

If the device is in a custom sleep state, then re-tuning
will fail. Add calls to sdio_retune_hold_now() and
sdio_retune_release() to prevent re-tuning before the
wake-up command. In the case re-tuning was needed, the
wake-up command might return an error, but the wake-up
is expected still to have happened, and the error is
anyway ignored.

Signed-off-by: Adrian Hunter <adrian.hunter@intel.com>
---
 drivers/net/wireless/brcm80211/brcmfmac/sdio.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/net/wireless/brcm80211/brcmfmac/sdio.c b/drivers/net/wireless/brcm80211/brcmfmac/sdio.c
index ab0c898..2ce81fb 100644
--- a/drivers/net/wireless/brcm80211/brcmfmac/sdio.c
+++ b/drivers/net/wireless/brcm80211/brcmfmac/sdio.c
@@ -773,11 +773,17 @@ brcmf_sdio_kso_control(struct brcmf_sdio *bus, bool on)
 	brcmf_dbg(TRACE, "Enter: on=%d\n", on);
 
 	wr_val = (on << SBSDIO_FUNC1_SLEEPCSR_KSO_SHIFT);
+
+	/* Cannot re-tune if device is asleep */
+	if (on)
+		sdio_retune_hold_now(bus->sdiodev->func[1]);
+
 	/* 1st KSO write goes to AOS wake up core if device is asleep  */
 	brcmf_sdiod_regwb(bus->sdiodev, SBSDIO_FUNC1_SLEEPCSR,
 			  wr_val, &err);
 
 	if (on) {
+		sdio_retune_release(bus->sdiodev->func[1]);
 		/* device WAKEUP through KSO:
 		 * write bit 0 & read back until
 		 * both bits 0 (kso bit) & 1 (dev on status) are set
-- 
1.9.1