From: Chaotian Jing <chaotian.jing-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
To: Ulf Hansson <ulf.hansson-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
Cc: Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>,
Matthias Brugger
<matthias.bgg-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>,
Catalin Marinas <catalin.marinas-5wv7dgnIgG8@public.gmane.org>,
Will Deacon <will.deacon-5wv7dgnIgG8@public.gmane.org>,
Chaotian Jing
<chaotian.jing-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
yong mao <yong.mao-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
Linus Walleij
<linus.walleij-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>,
Heiner Kallweit
<hkallweit1-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>,
Phong LE <ple-rdvid1DuHRBWk0Htik3J/w@public.gmane.org>,
linux-mmc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org,
linux-mediatek-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org,
linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
srv_heupstream-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org
Subject: [PATCH v5 10/12] mmc: mediatek: add latch-ck support
Date: Wed, 11 Oct 2017 10:41:34 +0800 [thread overview]
Message-ID: <1507689696-25928-11-git-send-email-chaotian.jing@mediatek.com> (raw)
In-Reply-To: <1507689696-25928-1-git-send-email-chaotian.jing-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
some platform(eg.mt2701) does not support "stop clk fix", in
this case, need set correct latch-ck to avoid crc error caused
by stop clock block-internally.
Signed-off-by: Chaotian Jing <chaotian.jing-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
---
drivers/mmc/host/mtk-sd.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
index a2f26c9..d75a93d 100644
--- a/drivers/mmc/host/mtk-sd.c
+++ b/drivers/mmc/host/mtk-sd.c
@@ -378,6 +378,7 @@ struct msdc_host {
u32 sclk; /* SD/MS bus clock frequency */
unsigned char timing;
bool vqmmc_enabled;
+ u32 latch_ck;
u32 hs400_ds_delay;
u32 hs200_cmd_int_delay; /* cmd internal delay for HS200/SDR104 */
u32 hs400_cmd_int_delay; /* cmd internal delay for HS400 */
@@ -1661,6 +1662,8 @@ static int msdc_tune_data(struct mmc_host *mmc, u32 opcode)
u32 tune_reg = host->dev_comp->pad_tune_reg;
int i, ret;
+ sdr_set_field(host->base + MSDC_PATCH_BIT, MSDC_INT_DAT_LATCH_CK_SEL,
+ host->latch_ck);
sdr_clr_bits(host->base + MSDC_IOCON, MSDC_IOCON_DSPL);
sdr_clr_bits(host->base + MSDC_IOCON, MSDC_IOCON_W_DSPL);
for (i = 0 ; i < PAD_DELAY_MAX; i++) {
@@ -1773,6 +1776,9 @@ static void msdc_hw_reset(struct mmc_host *mmc)
static void msdc_of_property_parse(struct platform_device *pdev,
struct msdc_host *host)
{
+ of_property_read_u32(pdev->dev.of_node, "mediatek,latch-ck",
+ &host->latch_ck);
+
of_property_read_u32(pdev->dev.of_node, "hs400-ds-delay",
&host->hs400_ds_delay);
--
1.8.1.1.dirty
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2017-10-11 2:41 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-10-11 2:41 [PATCH v5 00/13] mmc: mediatek: add support of mt2701/mt2712 Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 01/12] mmc: dt-bindings: Add reg/source_cg/latch-ck for Mediatek MMC bindings Chaotian Jing
2017-10-13 21:50 ` Rob Herring
2017-10-14 2:12 ` Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 02/12] mmc: mediatek: add support of mt2701/mt2712 Chaotian Jing
[not found] ` <1507689696-25928-3-git-send-email-chaotian.jing-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
2017-10-15 8:26 ` CK Hu
2017-10-16 7:49 ` Matthias Brugger
[not found] ` <a506506b-a326-6d54-9827-4fd82680700d-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2017-10-18 1:46 ` CK Hu
2017-10-18 10:00 ` Matthias Brugger
[not found] ` <1507689696-25928-1-git-send-email-chaotian.jing-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
2017-10-11 2:41 ` [PATCH v5 03/12] arm64: dts: mt8173: remove "mediatek, mt8135-mmc" from mmc nodes Chaotian Jing
2017-10-11 2:41 ` Chaotian Jing [this message]
2017-10-11 2:41 ` [PATCH v5 04/12] mmc: mediatek: make hs400_tune_response only for mt8173 Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 05/12] mmc: mediatek: add pad_tune0 support Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 06/12] mmc: mediatek: add async fifo and data tune support Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 07/12] mmc: mediatek: add busy_check support Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 08/12] mmc: mediatek: add stop_clk fix and enhance_rx support Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 09/12] mmc: mediatek: add support of source_cg clock Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 11/12] mmc: mediatek: improve eMMC hs400 mode read performance Chaotian Jing
2017-10-11 2:41 ` [PATCH v5 12/12] mmc: mediatek: perfer to use rise edge latching for cmd line Chaotian Jing
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1507689696-25928-11-git-send-email-chaotian.jing@mediatek.com \
--to=chaotian.jing-nus5lvnupcjwk0htik3j/w@public.gmane.org \
--cc=catalin.marinas-5wv7dgnIgG8@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=hkallweit1-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
--cc=linus.walleij-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org \
--cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-mediatek-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=linux-mmc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=matthias.bgg-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
--cc=ple-rdvid1DuHRBWk0Htik3J/w@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=srv_heupstream-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
--cc=ulf.hansson-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org \
--cc=will.deacon-5wv7dgnIgG8@public.gmane.org \
--cc=yong.mao-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox