Re: [PATCH v2 1/2] mmc: sdhci-esdhc-imx: disable clocks before changing frequency

[Stefan Agner <stefan@agner.ch>]

On 12.07.2018 10:06, Stefan Agner wrote:
> In the uSDHC case (e.g. i.MX 6) clocks only get disabled if frequency
> is set to 0. However, it could be that the stack asks for a frequency
> change while clocks are on. In that case the function clears the
> divider registers (by clearing ESDHC_CLOCK_MASK) while the clock is
> enabled! This causes a short period of time where the clock is
> undivided (on a i.MX 6DL a clock of 196MHz has been measured).
> 
> For older IP variants the driver disables clock by clearing some bits
> in ESDHC_SYSTEM_CONTROL.
> 
> Make sure to disable card clock before changing frequency for uSDHC
> IP variants too.

Ignore this patch, its a duplicate.

I should not have pressed Ctrl-C while git send-email is working :-)

--
Stefan

> 
> Signed-off-by: Stefan Agner <stefan@agner.ch>
> ---
>  drivers/mmc/host/sdhci-esdhc-imx.c | 12 ++++++------
>  1 file changed, 6 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c
> b/drivers/mmc/host/sdhci-esdhc-imx.c
> index 85fd5a8b0b6d..acacd8481473 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -708,14 +708,14 @@ static inline void esdhc_pltfm_set_clock(struct
> sdhci_host *host,
>  	int div = 1;
>  	u32 temp, val;
>  
> +	if (esdhc_is_usdhc(imx_data)) {
> +		val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
> +		writel(val & ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
> +			host->ioaddr + ESDHC_VENDOR_SPEC);
> +	}
> +
>  	if (clock == 0) {
>  		host->mmc->actual_clock = 0;
> -
> -		if (esdhc_is_usdhc(imx_data)) {
> -			val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
> -			writel(val & ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
> -					host->ioaddr + ESDHC_VENDOR_SPEC);
> -		}
>  		return;
>  	}