From: Alexandre Mergnat <amergnat@baylibre.com>
To: "Wim Van Sebroeck" <wim@linux-watchdog.org>,
"Guenter Roeck" <linux@roeck-us.net>,
"Rob Herring" <robh+dt@kernel.org>,
"Krzysztof Kozlowski" <krzysztof.kozlowski+dt@linaro.org>,
"Matthias Brugger" <matthias.bgg@gmail.com>,
"AngeloGioacchino Del Regno"
<angelogioacchino.delregno@collabora.com>,
"Chaotian Jing" <chaotian.jing@mediatek.com>,
"Ulf Hansson" <ulf.hansson@linaro.org>,
"Wenbin Mei" <wenbin.mei@mediatek.com>,
"Linus Walleij" <linus.walleij@linaro.org>,
"Zhiyong Tao" <zhiyong.tao@mediatek.com>,
"Bernhard Rosenkränzer" <bero@baylibre.com>
Cc: linux-watchdog@vger.kernel.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-mediatek@lists.infradead.org, linux-mmc@vger.kernel.org,
linux-gpio@vger.kernel.org,
Alexandre Bailon <abailon@baylibre.com>,
Fabien Parent <fparent@baylibre.com>,
Amjad Ouled-Ameur <aouledameur@baylibre.com>,
Alexandre Mergnat <amergnat@baylibre.com>
Subject: [PATCH v5 09/12] arm64: dts: mediatek: add ethernet support for mt8365-evk
Date: Fri, 07 Apr 2023 14:59:28 +0200 [thread overview]
Message-ID: <20230203-evk-board-support-v5-9-1883c1b405ad@baylibre.com> (raw)
In-Reply-To: <20230203-evk-board-support-v5-0-1883c1b405ad@baylibre.com>
- Enable "vibr" and "vsim2" regulators to power the ethernet chip.
Signed-off-by: Alexandre Mergnat <amergnat@baylibre.com>
---
arch/arm64/boot/dts/mediatek/mt8365-evk.dts | 57 +++++++++++++++++++++++++++++
1 file changed, 57 insertions(+)
diff --git a/arch/arm64/boot/dts/mediatek/mt8365-evk.dts b/arch/arm64/boot/dts/mediatek/mt8365-evk.dts
index 9760f181eb34..431078f8670e 100644
--- a/arch/arm64/boot/dts/mediatek/mt8365-evk.dts
+++ b/arch/arm64/boot/dts/mediatek/mt8365-evk.dts
@@ -88,6 +88,28 @@ optee_reserved: optee@43200000 {
};
};
+ðernet {
+ pinctrl-0 = <ðernet_pins>;
+ pinctrl-names = "default";
+ phy-handle = <ð_phy>;
+ phy-mode = "rmii";
+ /*
+ * Ethernet and HDMI (DSI0) are sharing pins.
+ * Only one can be enabled at a time and require the physical switch
+ * SW2101 to be set on LAN position
+ */
+ status = "disabled";
+
+ mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ eth_phy: ethernet-phy@0 {
+ reg = <0>;
+ };
+ };
+};
+
&i2c0 {
clock-frequency = <100000>;
pinctrl-0 = <&i2c0_pins>;
@@ -137,12 +159,47 @@ &mt6357_pmic {
#interrupt-cells = <2>;
};
+/* Needed by analog switch (multiplexer), HDMI and ethernet */
+&mt6357_vibr_reg {
+ regulator-always-on;
+};
+
/* Needed by MSDC1 */
&mt6357_vmc_reg {
regulator-always-on;
};
+/* Needed by ethernet */
+&mt6357_vsim2_reg {
+ regulator-always-on;
+};
+
&pio {
+ ethernet_pins: ethernet-pins {
+ phy_reset_pins {
+ pinmux = <MT8365_PIN_133_TDM_TX_DATA1__FUNC_GPIO133>;
+ };
+
+ rmii_pins {
+ pinmux = <MT8365_PIN_0_GPIO0__FUNC_EXT_TXD0>,
+ <MT8365_PIN_1_GPIO1__FUNC_EXT_TXD1>,
+ <MT8365_PIN_2_GPIO2__FUNC_EXT_TXD2>,
+ <MT8365_PIN_3_GPIO3__FUNC_EXT_TXD3>,
+ <MT8365_PIN_4_GPIO4__FUNC_EXT_TXC>,
+ <MT8365_PIN_5_GPIO5__FUNC_EXT_RXER>,
+ <MT8365_PIN_6_GPIO6__FUNC_EXT_RXC>,
+ <MT8365_PIN_7_GPIO7__FUNC_EXT_RXDV>,
+ <MT8365_PIN_8_GPIO8__FUNC_EXT_RXD0>,
+ <MT8365_PIN_9_GPIO9__FUNC_EXT_RXD1>,
+ <MT8365_PIN_10_GPIO10__FUNC_EXT_RXD2>,
+ <MT8365_PIN_11_GPIO11__FUNC_EXT_RXD3>,
+ <MT8365_PIN_12_GPIO12__FUNC_EXT_TXEN>,
+ <MT8365_PIN_13_GPIO13__FUNC_EXT_COL>,
+ <MT8365_PIN_14_GPIO14__FUNC_EXT_MDIO>,
+ <MT8365_PIN_15_GPIO15__FUNC_EXT_MDC>;
+ };
+ };
+
gpio_keys: gpio-keys-pins {
pins {
pinmux = <MT8365_PIN_24_KPCOL0__FUNC_KPCOL0>;
--
2.25.1
next prev parent reply other threads:[~2023-04-07 13:00 UTC|newest]
Thread overview: 37+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-04-07 12:59 [PATCH v5 00/12] Improve the MT8365 SoC and EVK board support Alexandre Mergnat
2023-04-07 12:59 ` [PATCH v5 01/12] arm64: defconfig: enable MT6357 regulator Alexandre Mergnat
2023-04-07 13:10 ` Alexandre Mergnat
2023-04-11 8:21 ` AngeloGioacchino Del Regno
2023-04-07 12:59 ` [PATCH v5 02/12] arm64: defconfig: enable Mediatek PMIC key Alexandre Mergnat
2023-04-07 13:10 ` Alexandre Mergnat
2023-04-11 8:21 ` AngeloGioacchino Del Regno
2023-04-07 12:59 ` [PATCH v5 03/12] dt-bindings: watchdog: mediatek,mtk-wdt: add mt8365 Alexandre Mergnat
2023-04-07 13:11 ` Alexandre Mergnat
2023-04-11 13:40 ` Rob Herring
2023-04-16 15:47 ` Guenter Roeck
2023-04-07 12:59 ` [PATCH v5 04/12] arm64: dts: mediatek: add watchdog support for mt8365 SoC Alexandre Mergnat
2023-04-07 13:11 ` Alexandre Mergnat
2023-04-07 12:59 ` [PATCH v5 05/12] arm64: dts: mediatek: add mt6357 PMIC support for mt8365-evk Alexandre Mergnat
2023-04-07 13:12 ` Alexandre Mergnat
2023-04-11 8:22 ` AngeloGioacchino Del Regno
2023-04-07 12:59 ` [PATCH v5 06/12] arm64: dts: mediatek: add mmc " Alexandre Mergnat
2023-04-07 13:12 ` Alexandre Mergnat
2023-04-11 8:22 ` AngeloGioacchino Del Regno
2023-04-07 12:59 ` [PATCH v5 07/12] arm64: dts: mediatek: set vmc regulator as always on amergnat
2023-04-07 13:13 ` Alexandre Mergnat
2023-04-11 8:23 ` AngeloGioacchino Del Regno
2023-04-11 11:17 ` Alexandre Mergnat
2023-04-07 12:59 ` [PATCH v5 08/12] arm64: dts: mediatek: add usb controller support for mt8365-evk Alexandre Mergnat
2023-04-07 13:13 ` Alexandre Mergnat
2023-04-11 8:24 ` AngeloGioacchino Del Regno
2023-04-07 12:59 ` Alexandre Mergnat [this message]
2023-04-07 13:13 ` [PATCH v5 09/12] arm64: dts: mediatek: add ethernet " Alexandre Mergnat
2023-04-07 12:59 ` [PATCH v5 10/12] arm64: dts: mediatek: add OPP support for mt8365 SoC Alexandre Mergnat
2023-04-07 13:14 ` Alexandre Mergnat
2023-04-11 8:24 ` AngeloGioacchino Del Regno
2023-04-07 12:59 ` [PATCH v5 11/12] arm64: dts: mediatek: add cpufreq support for mt8365-evk Alexandre Mergnat
2023-04-07 13:14 ` Alexandre Mergnat
2023-04-07 12:59 ` [PATCH v5 12/12] arm64: dts: mediatek: Add CPU Idle support amergnat
2023-04-07 13:14 ` Alexandre Mergnat
2023-04-07 13:08 ` [PATCH v5 00/12] Improve the MT8365 SoC and EVK board support Alexandre Mergnat
2023-04-07 17:50 ` Kevin Hilman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20230203-evk-board-support-v5-9-1883c1b405ad@baylibre.com \
--to=amergnat@baylibre.com \
--cc=abailon@baylibre.com \
--cc=angelogioacchino.delregno@collabora.com \
--cc=aouledameur@baylibre.com \
--cc=bero@baylibre.com \
--cc=chaotian.jing@mediatek.com \
--cc=devicetree@vger.kernel.org \
--cc=fparent@baylibre.com \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=linux-mmc@vger.kernel.org \
--cc=linux-watchdog@vger.kernel.org \
--cc=linux@roeck-us.net \
--cc=matthias.bgg@gmail.com \
--cc=robh+dt@kernel.org \
--cc=ulf.hansson@linaro.org \
--cc=wenbin.mei@mediatek.com \
--cc=wim@linux-watchdog.org \
--cc=zhiyong.tao@mediatek.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox