* Avoiding / recovering from end bit errors with sdio device (bcm43362)
@ 2014-05-26 9:13 Hans de Goede
0 siblings, 0 replies; only message in thread
From: Hans de Goede @ 2014-05-26 9:13 UTC (permalink / raw)
To: linux-mmc, Arend van Spriel
Hi All,
Every few hours (on average) the bcm43362 sdio wifi on 2 different
model allwinner boards I've throws an EBE error. The error handling
code successfully send a stop command after this, but still any
other command after that ends with a data time out error (which again
gets followed by a successful stop command).
Does this indicate a problem with the sdio device (driver), or could
this also be triggered by a bug in the mmc host driver?
One thing worth noticing hereby is that the brcmfmac drivers sdio
drivestrength table mentions that it is for 1.8v signalling, where
as the SoC side of things is using 3.3v signalling (this cannot
be changed).
Any help to further debug this would be greatly appreciated.
Thanks & Regards,
Hans
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2014-05-26 9:13 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2014-05-26 9:13 Avoiding / recovering from end bit errors with sdio device (bcm43362) Hans de Goede
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).