Re: [PATCH V2] mmc: core: improve reasonableness of bus width setting for HS400es

[Ulf Hansson <ulf.hansson@linaro.org>]

On 11 July 2018 at 05:00, Hongjie Fang <hongjiefang@asrmicro.com> wrote:
> mmc_select_hs400es() calls mmc_select_bus_width() which will continue
> to set 4bit transfer mode if fail to set 8bit mode. The bus width
> should not be set to 4bit in HS400es.
>
> When fail to set 8bit mode, need return error directly for HS400es.
>
> Signed-off-by: Hongjie Fang <hongjiefang@asrmicro.com>
> ---
>  drivers/mmc/core/mmc.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
> index 4466f5d..4bd6c09 100644
> --- a/drivers/mmc/core/mmc.c
> +++ b/drivers/mmc/core/mmc.c
> @@ -1021,8 +1021,11 @@ static int mmc_select_bus_width(struct mmc_card *card)
>                                  EXT_CSD_BUS_WIDTH,
>                                  ext_csd_bits[idx],
>                                  card->ext_csd.generic_cmd6_time);
> -               if (err)
> +               if (err) {
> +                       if (card->mmc_avail_type & EXT_CSD_CARD_TYPE_HS400ES)
> +                               return err;
>                         continue;
> +               }

I would rather let mmc_select_hs400es() check the return code from
mmc_select_bus_width().

So, if the return code isn't MMC_BUS_WIDTH_8, mmc_select_hs400es()
should bail out.

[...]

Kind regards
Uffe