From mboxrd@z Thu Jan 1 00:00:00 1970 From: Guennadi Liakhovetski Subject: [PATCH 2/3] sh: allow platforms to specify SD-card supported voltages Date: Fri, 14 May 2010 12:34:41 +0200 (CEST) Message-ID: References: Mime-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Return-path: In-Reply-To: Sender: linux-sh-owner@vger.kernel.org To: "linux-sh@vger.kernel.org" Cc: Ian Molton , Samuel Ortiz , linux-mmc@vger.kernel.org, Magnus Damm List-Id: linux-mmc@vger.kernel.org Boards can have different supplied voltages on different SD card slots. This information has to be passed down to the SD/MMC driver. Signed-off-by: Guennadi Liakhovetski --- drivers/mfd/sh_mobile_sdhi.c | 4 +++- include/linux/mfd/sh_mobile_sdhi.h | 3 +++ 2 files changed, 6 insertions(+), 1 deletions(-) diff --git a/drivers/mfd/sh_mobile_sdhi.c b/drivers/mfd/sh_mobile_sdhi.c index 7970fe8..d9e4701 100644 --- a/drivers/mfd/sh_mobile_sdhi.c +++ b/drivers/mfd/sh_mobile_sdhi.c @@ -106,8 +106,10 @@ static int __init sh_mobile_sdhi_probe(struct platform_device *pdev) mmc_data->hclk = clk_get_rate(priv->clk); mmc_data->set_pwr = sh_mobile_sdhi_set_pwr; mmc_data->capabilities = MMC_CAP_MMC_HIGHSPEED; - if (p) + if (p) { mmc_data->flags = p->tmio_flags; + mmc_data->ocr_mask = p->tmio_ocr_mask; + } if (p && p->dma_slave_tx >= 0 && p->dma_slave_rx >= 0) { priv->param_tx.slave_id = p->dma_slave_tx; diff --git a/include/linux/mfd/sh_mobile_sdhi.h b/include/linux/mfd/sh_mobile_sdhi.h index c7b47f8..4906780 100644 --- a/include/linux/mfd/sh_mobile_sdhi.h +++ b/include/linux/mfd/sh_mobile_sdhi.h @@ -1,10 +1,13 @@ #ifndef __SH_MOBILE_SDHI_H__ #define __SH_MOBILE_SDHI_H__ +#include + struct sh_mobile_sdhi_info { int dma_slave_tx; int dma_slave_rx; unsigned long tmio_flags; + u32 tmio_ocr_mask; /* available MMC voltages */ void (*set_pwr)(struct platform_device *pdev, int state); }; -- 1.6.2.4