Re: Dosemu 1.1.5 Binaries?

[Peter Celella <pcelella@ix.netcom.com>]

> I use 1.1.5 with rh9 and it works and compiles ok.  How does it fail?  
> 
> 

If I compile with linkstatic off and x on in compiletime-settings, I can
get dosemu both to compile and install. Unfortunately, when I try to run
any dos program, dosemu immediately closes and I get the following error
message in the terminal:

ERROR: MAPPING: cannot get IPC shared mem (Invalid argument)
 
This may have the following reasons:
- you do not have IPC configured into the kernel
- the limits are to low for the amount of memory you requested
  in /etc/dosemu.conf. In this case either decrease the XMS/EMS/DPMI
  amount in /etc/dosemu.conf or increase the kernel limits such as
  'echo 67108864 >/proc/sys/kernel/shmmax'

If I compile with linkstatic on and x off, dosemu also compiles and
installs, but of course I have no x support. I can run dos programs in
this case in the terminal, but besides not being the recommended way to
run dosemu, I don't have any mouse support.

Any ideas?