From mboxrd@z Thu Jan 1 00:00:00 1970 From: Hufnus Subject: Re: 1.3.2 builds but doesnt run Date: Mon, 23 May 2005 15:02:09 -0800 Message-ID: <20050523150209.090ba127.tonyb@sysdev.org> References: <429203DA.6070207@aknet.ru> Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <429203DA.6070207@aknet.ru> Sender: linux-msdos-owner@vger.kernel.org List-Id: Content-Type: text/plain; charset="us-ascii" To: linux-msdos@vger.kernel.org On Mon, 23 May 2005 20:24:58 +0400 Stas Sergeev wrote: > Hufnus wrote: > > it builds fine but when I run dosemu, it just exits with no > > error log... > The log is usually in ~/.dosemu/boot.log. > Please double-check that it is not there. Made a clean new make for the 4th time: Had made (2) 2.95.3 builds (with and without strip) on one host and made (1) 3.3.4 build on another host, they all FAILED to start on configurations that had been running with 1.3.1. Well made one more try w/2.95.3 and guess what, it now runs !!! ??? I think the problem was with /etc/dosemu.conf, in the past it had a line: $_vnet = (off) which was tolerated in previous versions < 1.3.2, with a msg: ERROR: Unknown vnet mode "0" But dosemu.bin would run! Enable that line and dosemu.bin (1.3.2) does not run and no output to boot.log either. One NOTE: I run Ziff Communications config.ctl to allow me to edit config.sys at start-up and my hdimage is an msdos 5.0 image: if I use the /usr/bin/dosemu from 1.2.0 then the and work fine, for config.sys editing. if I use the new /usr/bin/dosemu from 1.3.2 they do not work at all. "sdras vouitye" Sorry no Cyrlilic Tony -- __ __ _ I N C. http://www.sysdev.org / __|\\// __|| \ __ __ / tonyb@sysdev.org \__ \ \/\__ \||)|/ O_)\/ / \/ System Tools / Utilities |___/ || ___/|_ /\___|\_/ WIntel / Linux Device Drivers