RE: [RFC] nand/davinci: Fix comment to match the code

["Sudhakar Rajashekhara" <sudhakar.raj@ti.com>]

Hi,

On Wed, Aug 25, 2010 at 17:48:20, Wolfram Sang wrote:
> Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
> Cc: Sudhakar Rajashekhara <sudhakar.raj@ti.com>
> Cc: Sneha Narnakaje <nsnehaprabha@ti.com>
> Cc: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
> ---
> 
> Found while debugging a NAND issue with a dm365.
> 
>  drivers/mtd/nand/davinci_nand.c |    5 +++--
>  1 files changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
> index 2ac7367..53f864a 100644
> --- a/drivers/mtd/nand/davinci_nand.c
> +++ b/drivers/mtd/nand/davinci_nand.c
> @@ -369,8 +369,9 @@ compare:
>  	 * after setting the 4BITECC_ADD_CALC_START bit. So if you immediately
>  	 * begin trying to poll for the state, you may fall right out of your
>  	 * loop without any of the correction calculations having taken place.
> -	 * The recommendation from the hardware team is to wait till ECC_STATE
> -	 * reads less than 4, which means ECC HW has entered correction state.
> +	 * The recommendation from the hardware team is to initially delay as
> +	 * long as ECC_STATE reads less than 4. After that, ECC HW has entered
> +	 * correction state.
>  	 */
>  	do {
>  		ecc_state = (davinci_nand_readl(info,
> -- 

Thanks for pointing this out, but I have already corrected this and submitted
the patch. Artem Bityutskity has pushed this patch to his l2-mtd-2.6 / master
tree.

Regards,
Sudhakar